Instructions for Toe-In Adjustment on Demco Kar Kaddy SS Tow Dolly

Updated 06/08/2023 | Published 06/07/2023

Question:

Need instructions on setting the Toe-in on a Demco Kar Kaddy SS tow dolly.

asked by: Carl B

Expert Reply:

The toe-in adjustment steps for the # DM9713045 are as follows:

1. Put a mark on each side of the locking clamp on the tie rod.

2. Loosen the locking nuts on each end of the tie rod and then the four bolts on the tie rod locking clamp.

3. Turn the tie rod whichever direction is needed until you have a front measurement of 1/32” to 1/16” less than the back measurement.

4. Hold the tie rod and tighten the locknuts on each end.

5. Measure again to make sure the toe-in measurement has not moved.

6. Tighten the locking clamp bolts while holding clamp between the marks you previously put on the tie rod.

7. Reassemble the rest of the Kar Kaddy unit.

I have attached a picture of the instructions, which includes measuring the toe-in. The full written instructions are also attached below for your reference. This can be found on page 19.