Replacement Light For Ram 3,500lb Electric Jack # EJ-3520-BBX

Question

Question:

do you sell the replacement LED lamp for the ram power jack 3500 thanks

asked by: Steve P

0

Expert Reply:

Yes, we have the Replacement Light Board # EJ-3520-LT for the Ram 3,500lb Electric Jack # EJ-3520-BBX. We also have the Light Switch # EJ-3520-LSW and Cover # EJ-3520-BCV if the lens also needs replaced or the switch is bad.

expert reply by: Bud M

0

Answer 1

I attached a picture that I got from RAM jacks that shows how the RAM Jack switch part #EJ-3520-PSW that you referenced gets wired up.

view full answer...

Answer 2

Your RAM 3550 Jack will use both the Replacement Power Switch for RAM Electric Trailer Jack with Footplate #EJ-3520-PSW and the Replacement Light Switch for Electric Trailer Jack with Footplate #EJ-3520-LSW.

view full answer...

Answer 3

In regards to the Replacement Light Switch part #EJ-3520-LSW and Replacement Power Switch part #EJ-3520-PSW, you can reference the attached photo for help with installation but we don't have any wiring diagrams at this time.

view full answer...

Answer 4

If you can reply to this email with the pictures I can help you out. Just be sure to let me know what the product is they are installed on!

view full answer...

Answer 5

I have a suggestion for you as the rubber style plug is obsolete when Ram switched to the new Cover #EJ-3520-BCV style which uses the Cap #EJ-3520-BCP you found. With your cover having the odd egg shape you can enlarge the hole to a round hole which…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Replacement Light For Ram 3,500lb Electric Jack # EJ-3520-BBX

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching