Projection of Draw-Tite and Curt Class V Trailer Hitches for a 3rd Gen GM 2500/3500 Truck

Updated 03/23/2023 | Published 03/22/2023

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class V - 2"

(28)

$443.79

Question:

I see in the comments that this hitch has a drop of 6 5/8” but is it possible to get the projection out to the rear from one of the bolt holes? My truck has a utility body and the drop is good but curious about the projection. Also Is this same information available for the curt 15460? I need a class 5 but would prefer 2” over 2 1/2” Thanks

asked by: Ken K

Expert Reply:

I was able to run out to our warehouse and measure the projection of both the Draw-Tite DT45511 and Curt # C15460 trailer hitches you're asking about. I've attached some photos showing the dimensions I measured for you to check out! I measured from the rearmost mounting bolt hole to the opening of the hitch receiver as well as to the hitch pin hole.

expert reply by: Jon G