Correct Replacement Wheel Assemblies for the Yakima HoldUp 2 Bike Rack

Question

Question:

I have a Yakima hitch bike rack with a broken arm. I noticed you sell replacement arms. I found these numbers on my bike rack: 3148 8002443. Do you have a replacement for the broken arm? I have photos but dont see a way to attach them to this message.

asked by: David M

1

Helpful Expert Reply:

I did some research and it appears that the numbers you gave go to the Yakima HoldUp Bike Rack for 2 Bikes # Y02443.

With that being said, since you're needing to replace a broken arm you are actually going to need to replace the entire wheel assemblies with both the Replacement Front Bike Tray Assembly for Yakima HoldUp Bike Carriers # 8890280 & the Replacement Rear Bike Tray Assembly for Yakima HoldUp Bike Racks # 8890281 as just the replacement arm is not available.

If you have the grey version of this rack, then you can use the # Y90198 for the rear and # Y90197 for the front instead.

expert reply by: Bryce D

1

Answer 1

The model number for a Yakima HoldUp bike rack like item #Y02443 will be on the rear side of the front cradle facing away from the vehicle as shown in the picture below. If you have a black Yakima HoldUp bike rack or the 2-bike add on item #Y02446…

view full answer...

Answer 2

I may have a solution for you, but the #8880832 isn't going to fit into the end on your Yakima HoldUp with a 2" shank; it may look like you could get it into the end but there's not a hole for a pin to be installed even if it did fit, so…

view full answer...

Answer 3

Hey Mike, We do have replacement keys for your Yakima HoldUp Bike Rack #Y02443. What is the number on your lock cores? It would have been on the face of the keys you received and written down on the instructions once you received the rack. If you can…

view full answer...

Answer 4

Hello Peggy, thanks for reaching out. The only way we can provide the correct key would be if you have the key number. Without that, there is no way of knowing what key will open your lock. If the locks are currently unlocked, you can use the change…

view full answer...

Answer 5

It truly depends on what bike rack you have and what key code you have with the locks. If the key you have doesn't turn the lock, it most likely is not the correct key for the rack. The best way to proceed is to make sure the key you have matches…

view full answer...

Answer 6

Since you have a Yakima Evo HoldUp the correct replacement rear tray would be the part #8880832.

view full answer...

Answer 7

I'm sorry to hear that you were hit by a car (hopefully you're ok!) and we do have exactly what you need, though the arm by itself is not something that is available from Yakima as a replacement part. For your Yakima HoldUp 2-Bike Rack…

view full answer...

Answer 8

The Yakima HoldUp 2 Bike Rack for 2" Hitches - Platform Style - Tilting #Y02443 is different from the Yakima HoldUp EVO 2 Bike #Y02479 in a couple ways. The original could hold bikes up to 60 lbs each versus the EVO holding up to 50 lbs per…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Correct Replacement Wheel Assemblies for the Yakima HoldUp 2 Bike Rack

Products Featured in This Question

Continue Researching