Is Dielectric Grease Good For Protecting My 4-Pin Trailer Connector?
Published 02/07/2023
Products Featured in This Question
Question:
Hi there! I would love some advice on what is the best way to protect a 4 pin trailer plug when not in use. I read that dielectric grease may be used. If thats the case, how should I apply it on and how much of it? Would I need to clean it off prior to use? This is the first time I have owned a hitch with wiring and I would love to take good care of it. Thank you very for your time!
asked by: Tammy
Expert Reply:
Yes, dielectric grease like the Dielectric Grease for Electrical Connectors # 11755 can and should absolutely be used on electrical connectors like your 4-pin trailer connector.
Dielectric grease does a great job of protecting your equipment from corrosion caused by water damage, which is the most common cause of corrosion.
To apply this to your connector, you'll just need to apply a healthy amount to your connector, re-applying periodically.
You can also use the Curt Trailer and Vehicle 4-Pole Flat Cover Set # C58761 as well which will keep your 4-way covered when not in use to further add protection.
I've attached a video where one of our techs will run you through how you should apply this grease to your connector for you to check out as well.
Product Page this Question was Asked From
Dielectric Grease for Electrical Connectors, 2 oz.
- Accessories and Parts
- Trailer Wiring
- Wiring
- Dielectric Grease
- LubriMatic
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: flat tow wiring harness accessories and parts
- Search Results: flat tow wiring harness
- Search Results: flat tow wiring
- Search Results: grease
- Search Results: tester
- Search Results: dialectic grease
- Search Results: permatex
- Shop: Vehicle Tow Bar Wiring
- Shop: Trailer Wiring
- Video: Ultimate Overview of the Dielectric Grease for Electrical Connectors, 2 oz.
- Shop: Dielectric Grease for Electrical Connectors, 2 oz.
- Shop: Blue Ox EZ Light Custom Plug-In Tow Bar Wiring Kit
- Shop: Blue Ox 7-Wire to 6-Wire, Coiled Electrical Cord
- Shop: Blue Ox 7-Wire to 4-Wire, Coiled Electrical Cord - 7' Long
- Shop: Curt Tow Bar 7-Way to 6-Way Coiled Adapter Cord w/ 6-Way Socket - 7' Long
- Q&A: How to Prevent Corrosion on a 4-Way Trailer Connector
- Video: Loctite Bulb, Lamp, and Electrical Connection Dielectric Grease: The Breakdown
- Shop: Loctite Bulb, Lamp, and Electrical Connection Dielectric Grease - 0.33-Oz Tube
- Shop: Curt 7-Way to RV Socket LED Circuit Tester - Vehicle End
- Shop: Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Replacement For A 0.9 cu ft Furrion RV Microwave
- Q&A: RV Microwave Replacement for 2011 Jayco Pinnacle Fifth Wheel
- Shop: Fifth Wheel Hitch
- Video: Yakima Rack and Roll Trailer Assembly
- Video: TowSmart Hitch Installation | 2019 Mazda CX-5 DIY Guide
- Shop: Brake Controller
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Video: Set up: Curt Trailer Hitch Receiver on a 2012 BMW X5
- Video: CE Smith Post-Style Guide-Ons with LED Lights for Boat Trailers Review
on Accessories and Parts
