Redarc Tow-Pro Liberty Mounting Hole Dimensions for 2020 Forest River Sunseeker Motorhome

Published 02/06/2023

Products Featured in This Question

Redarc Tow-Pro Liberty Brake Controller - Dash Knob - Up to 2 Axles - Proportional

(2504)

$190.00

Tekonsha Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In

(124)

$29.54

Redarc Tow-Pro Wiring Adapter for Tekonsha Brake Controller Harness

(96)

$27.00

Question:

Good Morning, I have a 2020 Sunseeker 32 MH that is actually built on a 2019 E450 chassis. There is a brake controller plug behind the top center of the dash and of course a hitch. I would like to buty a Redarc Liberty brake controller and am wondering what size hole is required for the control knob that goes in the dash. I may have choices where to locate the control and would like to know if I need or can use the switch . Your expertise would be appreciated. Thanks

asked by: Thomas M

Expert Reply:

Thanks for reaching out!

The control knob for the Redarc Tow-Pro Liberty # RED24FR requires both a 1/8" and a 3/8" hole to be drilled one above the other as you can see in the attached photo. The centers of these holes should be 0.3" apart so overall you're looking at an area about 3/8" wide x 9/16" tall minimum.

It sounds like your 2020 Forest River Sunseeker Motorhome has the tow package wiring so you'll be able to install the Tow-Pro Liberty using the wiring harness adapters # 331-TPH-017 and # 3063-P.

expert reply by: Jon G