Can Trailer Valet JXC Trailer Jack # TV94FR Fit 2016 Jayco Jay Flight SLX 265RLSW  

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. A 4,600 pound trailer would have a tongue weight between 460 and 690 pounds. Somewhere between a 1,000 to 2,000 pound capacity jack would be fine. Having a jack that…

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Yes, you can! So long as our Kenda Loadstar 5.30-12 Bias Trailer Tire with 12" White Wheel item #AM30820 is the same size and bolt pattern as what's on your Ironton trailer it can be used not only as a spare but also on your trailer with the…

Thanks for the photos, Bill! It looks like you've got some Optronics Millennium lights on your InTech trailer so you'll need the following parts to replace them: - Round Marker Light #OPT44FR or #11212278B - Chrome Bezel #00212217B -…

The two options you're referring to, the Dexter Trailer Axle w/ Electric Brakes #7685269-EB and Trailer Axle w/ Electric Brakes #e52SR are essentially the same when it comes to their specs. The only difference is the manufacturer with one being…

It is an easy replacement for you based on the picture you sent. The opening for most A-frame jacks require an outer diameter of 2-1/4 inches. I recommend you use a round jack like the Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel -…

The 23-5/8 inch width is the widest point and is actually for the metal rod. The bracket width is 22-1/8 inches from edge to edge. I measured this product for you to confirm and have attached a photo to assist.

So there are a couple potential issues here with your trailer's electric brakes that are grabbing hard and releasing on their own. The information about other trailers working fine on the same truck is important because that means we can rule out…

Sounds like you are looking for a lower profile jack for your trailer so that the tailgate of the vehicle does not interfere with it. I went to our warehouse and was able to locate an a-frame jack that measured less than 12 inches from the bracket…