Angle of Different Stabilizer Positions for Ark Drop Down Corner RV Stabilizer Jacks

Question

Question:

Can the Ark Down Stablizer jacks lock in the upright position in either direction? What are the different angles it provides? I know the description says multiple angles, but I need specirfic degrees.

asked by: Garrett E

0

Expert Reply:

The Ark Drop Down Corner RV Stabilizer Jacks # ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

expert reply by: Robin H

0

Answer 1

Hey Kevin! the Ark XO Drop Down Corner #ARK87FR has a support capacity of 1,925 lbs per jack. For some reason a capacity made its way onto the Ark Drop Down Corner Steadies #ARK34FR page and others like it which will need to be corrected. However,…

view full answer...

Answer 2

Hey Brent! I would mount the Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR on the outside as close to the corners as possible. If you mount them in the center of the trailer they won't add nearly as much stability. If you're worried about…

view full answer...

Answer 3

The vehicle side of the Lock N Roll Articulating Trailer Hitch #336VS501 can be locked to the vehicle's 2-inch receiver hitch using any standard pin lock such as #e98880. The mating part that bolts or welds on to the trailer #336TS508 will only…

view full answer...

Answer 4

The Ark stabilizers won't affect your ground clearance, but to determine the right ones that really depends on how high up your frame is off the ground. Overall, the Ark RV Stabilizer Jacks #ARK34FR are 16.6" collapsed and 23.6"…

view full answer...

Answer 5

Scissor jacks don't actually support that much of the trailer's weight, more just the downward force on the trailer from moving around inside of it so the Scissor Stabilizer Jacks w/ Handle #TJSCHD-24-4 you were looking at would be more than…

view full answer...

Answer 6

I checked with Ark and they informed me that their Drop Down Corner Stabilizer set part #AR34FR will work great on your 2015 Passport Grand Touring Ultra Lite but these jacks do not have a weight capacity. This is what they sent me: "The #AR34FR…

view full answer...

Answer 7

The Ark Drop Down Corner RV Stabilizer Jacks - 2-1/2' Long Corner Steadies item #AR94FR weigh 13 lbs a piece.

view full answer...

Answer 8

We don't offer a combination leveler/stabilizer jack, but if you're wanting something in a stabilizer jack that is very sturdy, you can't go wrong with the ARK Drop Down Corner stabilizer jacks. They're available in a powder coat or a…

view full answer...

Answer 9

Hello Daniel, thanks for reaching out. The Ark Drop Down Corner RV Stabilizer Jacks #AR94FR are 19" long when fully retracted. They have 11" of travel so they go out to 30" long overall when fully extended. I edited a picture for you…

view full answer...

Answer 10

The ARK #ARK94FR stabilizer jacks could work for you, but you'll likely find they're too tall. The jacks measure 30 inches tall when fully extended or 19-1/2 inches tall when fully retracted. The existing 400914-03 jacks on your Airstream…

view full answer...

Answer 11

Hey Paul! I can recommend a few of the parts you're going to need but you're also going to have to replace your hubs. In order to do this I need you to tell me the part numbers stamped into the side of the bears on one of them and also what…

view full answer...

Answer 12

The Ark Drop Down Corner RV Stabilizer Jacks #AR94FR does include the mounting plate which is loosely installed on the jack. This plate has a flat surface area which is 4.6" long x 1.83" wide. It would typically be welded directly to the…

view full answer...

Angle of Different Stabilizer Positions for Ark Drop Down Corner RV Stabilizer Jacks

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching