Replacement For Venture Landing Gear Lead Leg

Question

Question:

VM900R landing jack I need to replace the rod and bolt.

asked by: Lee

0

Expert Reply:

There is not a replacement rod for Venture landing gear, so what you will need to do is replace the lead leg with the Replacement Lead Leg for Venture 5th Wheel RV Landing Gear # LC119102.

expert reply by: Kyle S

0

Answer 1

For your VMC900R landing gear if you want to replace the lead leg I recommend the Replacement Lead Leg for Stromberg Carlson Landing Gear - 33-1/2" #LG-177202 and then for the follow leg #LG-177201. I've attached a photo of the measurements…

view full answer...

Answer 2

Though I could not find anything about the T46059 repair kit you referenced, but odds are the jack isn't rated high enough for the weight of your trailer. Or there is more than just the gears that need to be replaced. What you will probably want…

view full answer...

Answer 3

Hey Ronald, Besides replacing the batteries themselves, we have a converter that is a good replacement for yours to tackle those lithium batteries. The Progressive Dynamics 9300 Series #PD79RR is what I would recommend. It is similar in terms of…

view full answer...

Answer 4

Thanks for reaching out and for all of the information! For your 2018 Grand Design Reflection 312BHTS I highly recommend using the 4-Leaf Double-Eye Spring #e47SR which is rated for up to 6,000 lb axles and measures 25-1/8" from center eye to…

view full answer...

Answer 5

A 5200 lb axle is actually a 6000 lb axle that's been de-rated by using a different outer bearing. The proper replacement leaf spring will depend on how long the original springs are. Because leaf springs flatten out and become longer as they…

view full answer...

Answer 6

Yes, the Replacement Lead Leg #LC119102 is the correct leg for your VMC900R Venture Landing Gear on your 2009 Keystone Cougar 5th wheel. The Replacement Follow Leg #LC119101 is also available if you would like to replace the follow leg as well on…

view full answer...

Answer 7

The Lippert replacement leg part #LC119102 that you referenced is the correct replacement for your Venture landing gear VMC900R.

view full answer...

Answer 8

The 9160A is no longer available so for a replacement I recommend the Progressive Dynamics PD9200 Series Battery Converter Charger with Charge Wizard #PD9260C. The only real difference between this and your old 9160A is the charging cycle. Since this…

view full answer...

Answer 9

Hey Mike! The Progressive Dynamics 9300 Series RV Converter Charger #PD79RR you looked at will make a great replacement. This has the same 60A output as your PD9160A and includes the Charge Wizard. This works with flooded lead acid, AGM, and LiFePO4…

view full answer...

Answer 10

The difference in the repair kits for your VMC900R will be the Drive Shaft; a lead leg kit will have a different shaped shaft than the follow leg. The replacement Landing Gear Kit for Venture Follow Legs is #LC146060, while the Lead Leg repair kit is…

view full answer...

Answer 11

Doug, the correct replacement for your Inteli-Power 9100 Model PD9160A is the Progressive Dynamics PD9200 Series Battery Converter Charger with Charge Wizard #PD9260C. The only difference between this one and the one you have right now is the charge…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement For Venture Landing Gear Lead Leg

Product Page this Question was Asked From

Continue Researching