Trailer Coupler Storage Lock Keyed Alike For 1-7/8", 2", and 2-5/16" Couplers

Question

Question:

Im inquiring about buying 10 of the trimax 100 coupler locks. I would like to have all of them keyed the same. is this an option?

asked by: Shannon R

0

Expert Reply:

I do have a recommendation as the Trimax Dual Purpose Coupler Lock # TMX47FR we do not offer for keyed alike. We do have the similar Fastway Universal Coupler Lock # FA86-0015-308 which will all be keyed the same.

expert reply by: Bud M

0

Answer 1

The 1/2" Trimax Dual Purpose Coupler Lock #TMX77FR measures 4" across to the U-Shaped locking pin. We also have the 9/16" Trimax Dual Purpose Coupler Lock #TMX67FR and Trimax Dual Purpose Coupler Lock with Ballistic Grade Nylon Housing…

view full answer...

Answer 2

You certainly can use the Trimax Coupler lock #TMX47FR with the Demco 2-5/16" Ez latch coupler like the #DM14040-81. The Demco coupler is 2-7/8" wide on the outside so it will undoubtedly fit with the Trimax lock, which is more or less…

view full answer...

Answer 3

I have an alternative option for you, but the Trimax Dual Purpose Coupler Lock and U-Lock #TMX77FR is only available as a unique keyed option. For a similar style that can be keyed alike I recommend the Fastway Universal Trailer Coupler Lock…

view full answer...

Answer 4

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 5

Any circuit boards included in a fan would definitely be brand and/or model specific so I checked with Ventline for a replacement for the board in your Northern Breeze V2501 fan. Unfortunately, Ventline no longer has stock of those circuit boards.…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 12

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Trailer Coupler Storage Lock Keyed Alike For 1-7/8", 2", and 2-5/16" Couplers

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching