What is Distance from Hitch Pin Hole to Retaining Pin of Lock N Roll Articulating Trailer Coupler

Question

Question:

Good Morning, What is the distance from the 5/8 hitch pin hole, to the center of the horizontal coupling pin that meshes with the vehicle side coupling?

asked by: Daniel T

1

Helpful Expert Reply:

The distance from the center of the hitch pin hole of the Lock N Roll Articulating Trailer Coupler for 2" Receivers # 336TS510 to the center of the coupling pin measures 9-3/4 inches.

expert reply by: Jameson C

1

pin to pin dimensions
(click to enlarge)

Answer 1

Although the Lock N Roll Articulating Trailer Coupler for 2" Receivers #336TS510 has a 5/8" pin hole to secure it to your trailer, you can definitely weld this to your trailer instead. Just be sure the work is done by a qualified welder…

view full answer...

Answer 2

Yes, we carry the Lock N Roll Articulating Trailer Coupler for 2" Receivers in 3 different lengths. The #336TS510 you found is 9-3/4" from the hitch pin center hole to the center of the coupler head. We also have it in a 18-1/2" Length…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

What is Distance from Hitch Pin Hole to Retaining Pin of Lock N Roll Articulating Trailer Coupler

Product Page this Question was Asked From

Continue Researching