How to Wire Dexter DX7.5 Drop-N-Go Brake Actuator Electric Lockout on Trailer With 7-Way

Updated 07/11/2022 | Published 07/07/2022

Products Featured in This Question

Dexter DX7.5 Drop-N-Go Brake Actuator - Disc Brakes - 2" Ball - Zinc Plated - 7,500 lbs

(90)

$382.54

14 Gauge Wire - Yellow Primary - Per Foot

(48)

$0.48

Question:

Do you have a wiring diagram for the Dexter DX7.5 -N-Go Brake Actuator - Disc Brakes - 2inch Ball - Zinc Plated - 7,500 lbs, to a 7 pin connector

asked by: Vicente S

Expert Reply:

The Dexter DX7.5 Drop-N-Go Brake Actuator # 099-175-20 should be wired to the reverse light circuit on your 7-way. Although I do not have a specific wiring diagram, this is a simple process. There are two wires on your brake actuator. One will be the ground and the other connects to the reverse lights. These are interchangeable so you don't have to worry which you use.

The reverse lights should run to the middle pin on your 7-way connector. The wire color is typically going to be yellow or purple. If you need additional wire to connect to the reverse light circuit you can use the # DW02412-1.

I have attached a diagram showing the typical color code for a 7-way, along with a helpful article on 7-way wiring for your reference.

expert reply by: Robin H