Hands-On with the Dexter Premier Disc Brake Kit Video

Hey Ben, yeah it sounds like your trailer has a 3,500 lb capacity axle based on what you mentioned so the correct disc brake kit part #T2HRCM10DAC that you referenced does fit.

In order to find a replacement you will have to identify what you currently have on the trailer. Since you mentioned the rotor I'm assuming you have disc brakes. If you have an over-the-hub rotor you won't need to replace the entire hub, just…

Yes, the mounting brackets included with the DeeMaxx Disc Brake Kit #DE72FR are also stainless steel.

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

The disc brake kit part #T2HRCM10DAC is the correct disc brake kit for your boat trailer that has 3,500 lb axles and a 5 on 4-1/2 inch bolt pattern. For bearings you'd want the part #L68149 and #L44649, for races part #L68111 and #L44610 and then…

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

Yes, since your trailer has Dexter UFP 3,500 lb brakes on it currently the Titan Premier Disc Brake Kit part #T2HRCM10DAC would fit it and work well as this fits the same 3,500 lb axle spindle as your current kit.

The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-20 is a direct replacement for your Tie Down model 70E disc brake actuator with a 7000 lb capacity (Tie Down was bought out by Dexter back in 2017). Although I don't have a way of decoding your…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

So you'd have to change out everything, including the brake mounting flange, as the 6-bolt is simply not used anymore. There isn't a direct replacement from Dexter, so you'd need a 5-bolt brake mounting flange welded on (assuming you have…

For your 2004 Ford F-350 diesel I recommend the P2 #90885 with wiring harness #3035-P. The P2 is one of our most popular brake controllers of all time because it is easy to set up and use and it is reliable. This is a proportional controller that…

On your 2004 Ford F-350 the factory port to plug in a brake controller is located near the center console to the right of the steering column. I have linked a video that shows how to access it.