Ordering Four Longer Torklift Camper Turnbuckles Similar to Derringer

Question

Question:

I made my own frame mounts for my camper. I did frame mounts for the front and rear of the camper. Can I purchase this item with all long tie downs?

asked by: Greg K

0

Expert Reply:

The Derringer set you referenced is only available in a set of 4 that has two longer and two shorter turnbuckles but we do have the Torklift Springload part # TLS9050A which is a set of two that has a range of 35 to 45 inches which is similar to the longer ones of the Derringer set.

expert reply by: Jameson C

0

Answer 1

Brophy recommends using their rigid tie down hardware kit, part #TDHP, as their tie downs provide a small amount of flex.

view full answer...

Answer 2

The correct set of Torklift Camper tie downs for your 2005 Dodge Dakota 5 foot bed without steps are the part numbers TLD2114 and #TLR3500. For turnbuckles you'd then want the part #TLS9000 which would work well on your import camper.

view full answer...

Answer 3

The HappiJack Qwik Load Upgrade Kits are only sold in quantities of 4 like with the part #LC182894.

view full answer...

Answer 4

I reached out to HappiJac and they do not offer any replacement handles for your HappiJac Qwik-Load Turnbuckles #LC182895. I was able to find the Upgrade Kit #LC182894 which will include 4 new handles for less than having to replace all your…

view full answer...

Answer 5

HappiJac hasn't really developed a great solution for locking their turnbuckles yet. There are some options, but it also depends on what HappiJac turnbuckles that you have. If you have the HappiJac Qwik-Load Turnbuckles #LC182895, you would just…

view full answer...

Answer 6

TorkLift Derringer Handles for Camper Tie-Down Turnbuckles #TLS9528 are offered only in the standard black finish shown on the linked page. These fit 1/2-inch threaded rods found on most major camper turnbuckle assemblies.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Ordering Four Longer Torklift Camper Turnbuckles Similar to Derringer

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching