To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
These tie-downs bolt directly to the truck’s frame—the strongest part of the vehicle—so your camper rides low and solid through wind, turns, and bumps. By securing at the frame instead of the bed or bumper, they keep the camper’s center of gravity low and evenly distributed. That means less sway from crosswinds and no shifting around on rough roads, so your truck handles just like it should mile after mile.
Each bracket uses pre-existing holes in the frame for a clean bolt-on install with little to no drilling required. The fit is completely custom, so the tie-downs mount tight against the frame with minimal loss of ground clearance. Once installed, setup is simple—just add your turnbuckles (sold separately) and you’re ready to secure your camper for travel.
When you’re not hauling a camper, you can remove the arms from the brackets, leaving almost nothing visible under the vehicle. The frame-mounted design tucks up neatly, preserving your truck’s clean lines without bulky hardware hanging down. It’s a setup that works hard when you need it but disappears when you don’t.
Made of heavy-duty 1/4" thick steel, these tie-downs are engineered for strength and durability. The high-impact powder coat adds an extra layer of protection against rust, chips, and road wear. Whether you’re driving through rain or kicking up dust on long trips, these mounts are built to keep their integrity season after season.
Each arm features two anchor holes to let you fine-tune how far they extend from the body and get the right reach for your turnbuckles. This flexibility helps clear fenders or bowed sidewalls while keeping tie-down tension just right. The offset anchor points hold your camper from multiple angles for a snug fit that stays put no matter where you drive.
Customer Satisfaction Score:
100% were satisfied with this product
0% of customers were not satisfied
Ratings & Reviews
Paul
9/27/2026
These tie downs are great, so easy to use. Camper never budged a hair
Andrew N.
9/27/2026
Clay
7/31/2026
A year later and I would not do anything different. Absolutely the best system available especially paired with the fast guns. The camper is solid mounted and does not move. Yet can still be off loaded in just a few minutes. Remember good stuff isn’t cheap and cheap stuff isn’t good.
Christopher H.
7/31/2026
Gwendolyn Y.
1/21/2025
Hey William. Thanks for sharing your experience you had with Paula! Hopefully its not too cold where you are at and you can use your new tiedowns sooner rather than later.
Do you have a question about this Truck Camper Tie Down?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Lazer S.
9/16/2025
It definitely is safe the way you have them, Paul! In a perfect world, the turn buckles would be perfect vertical, but this an imperfect world and not all campers have the attachment points in the same place. If you take a look at some of the installed pictures on the TorkLift Locking FastGun Turnbuckles # TLS9529-2-LK page, you can see most of them are at an angle. It's perfectly normal. Are you running any suspension enhancement on your Silverado?