Troubleshooting E9 Code After Replacing Surge Module on Power Watchdog Surge Protector
Updated 05/26/2022 | Published 05/25/2022
Question:
we replaced the surge module but still have a E9 code? does something need reset?
asked by: Kim
0
Expert Reply:
That E9 code should go away on it's own once you've installed the Replacement Surge Module # HU38FR. Since that code is remaining you'll want to open up the Power Watchdog Surge Protector again and check the connections you made. Make sure they are clean and secured because if they aren't that could be what's still throwing that code.
If the install looks good then it sounds like you have a warranty issue you'll want to pursue.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Replacement Surge Module for Power Watchdog Surge Protector - 50 Amp
- Accessories and Parts
- RV Surge Protectors
- Surge Module
- 50 Amp
- Hughes Autoformers
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Is The Power Watchdog Surge Protector App Free To Use?
- Q&A: Difference Between Different 50 Amp Power Watchdog Surge Protectors
- Q&A: Hughes Watchdog Surge Protector Warranty Information
- Q&A: How Does the Portable Power Watchdog Surge Protector # HU42VR Connect to Wifi
- Q&A: Replacement Module For Portable Power Watchdog Surge Protector 50 amp
- Q&A: Error Codes on a Portable Power Watchdog Surge Protector
- Q&A: Need Replacement Surge Protection Module For Power Watchdog Surge Protector HU82VR
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Using a Portable Generator on RV
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Converting Your RV Water Heater to Tankless