Can You Use A 1/2 Wheel Stud On A Hub That Uses 9/16 Wheel Studs?
Updated 03/28/2022 | Published 03/25/2022
Question:
Good Afternoon, Is it possible to use part number RG03-080 inside of a Lippert 6K hub?
asked by: Tylan T
Expert Reply:
It is possible to use the Replacement Trailer Hub Wheel Stud # RG03-080 which is 1/2" wheel stud, inside your Lippert 6k hub, which uses a 9/16" stud.
You'll want make sure that the stud is drive in as opposed to threaded, and, you'll also want to verify that the length and the knurl diameter is the same. For example, the Replacement Trailer Hub Wheel Stud # RG03-080 has a knurl diameter of .54"
I have included a picture detailing which parts to measure, if you're able to provide me with the measurements of your current studs, I can see if we have a replacement.
(click to enlarge)
Product Page this Question was Asked From
Replacement Trailer Hub Wheel Stud, Drive-In, 1/2" x 2-3/4" - Qty 4
- Accessories and Parts
- Boat Trailer Wheels
- Trailer Hubs and Drums
- Trailer Tires and Wheels
- Wheel Studs
- 1/2 Inch Diameter
- Drive-In Stud
- 2-3/4 Inch Long
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Length of Catch Arm on UWS Lock Cylinder UWSLOCKCH501 and Can Lock Be Keyed Alike
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Replacement Trailer Wheel Studs With 1/2 inch Diameter
- Q&A: Wheel Stud Recommendation to Fit Dexter 7,000 lb Hubs
- Q&A: How To Determine the Correct Size Lug Nuts For a Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: How To Determine the Weight Capacity For a Trailer Axle
- Q&A: Can I Take the Inner Tube of the Ram Gooseneck # GCSQTW-30008 and Put it in My Outer Tube on Trailer
- Article: Trailer Tire Sizing
- Article: Which Hitches are Made in the USA
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Rust Prevention