Refresh a wheel end without chasing parts. This idler hub kit has the bearings, races, and seal already greased and installed, plus everything else needed to complete the install so you can get rolling again.
Replacing a hub can turn into a mess when you still have to pack bearings and match small parts before the wheel goes back on. This idler hub is pre-greased with the bearings, races, and seal already installed, so you have less prep work before mounting it on a compatible 2,200-lb axle.
When bearing or hub trouble happens on the road, having a spare hub can keep the trip from stopping there. This pre-assembled Lippert hub packs easily in your tow vehicle, and because the bearings, races, seal, lug nuts, and easy lube dust cap are included, it gives you a faster path to getting the trailer rolling again.
This hub fits 13" to 15" wheels with a 5 on 4-1/2" bolt pattern and 1/2" zinc-plated wheel studs. It is made for idler wheel ends only and cannot be used with trailer brake systems.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone. Steven here with the etrailer. Today we're taking a look at a replacement Lippert trailer idler hub kit. So, folks, if you've got a worn out or damaged hub on the trailer, replacing it could involve tracking down quite a few individual pieces. This will simplify it because now you're going to get everything you need with the hub and all the components to replace one complete wheel end. I will put up on the screen all the components that you're going to get as far as the grease seals, the races, and the bearings.
All that's pre-packed. It's pre-greased inside of there, along with that grease seal in the back and the rear or inner bearing. Obviously, you're going to get the grease cap here with the rubber plug. That way you can reach any kind of easy loop spindles if you're equipped with them, all your lug nuts and the washer, the castle nut, and the cotter pin as well. So this is going to make it useful not only when you're replacing a hub at home, but something you can also just get an extra one with and keep on your trailer in a toolbox as a spare.
One of the hardest things to do, believe it or not, is find a lot of trailer parts when you're on the side of the road. Some places will have them, but you'll find a lot of places actually don't just because even though it's a five-lug idler hub, there might be different lug patterns. In this case, it's a 5 on 4 1/2-inch lug pattern. The way you get that is measure center of one stud directly across to the outside of the diagonal studs. In this case, it'd be 4 1/2 inches.
You may get 4 3/4, 4 5/8. There's different ones for five lugs. So it's very important that you know your lug pattern as well when you're ordering this kind of stuff. Now this is commonly going to be found on about a 13 to 15-inch wheel, and the stud sizes here are 1/2 inch. Folks, that's going to wrap up our quick look together at this Lippert trailer idler hub kit.
I'm Steven. Thanks for watching.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.





Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.