Is There a Gasket for the Optronics Side Marker Lights MCL44 Series

Updated 03/01/2022 | Published 02/27/2022

Question:

For use on a 2008 fiberglass Casita: I am trying to find a gasket for the Optronics MCL 44RB1 side marker light. I have the new lights to install, but I need to raise them up to give the wires clearance under the fixture. This marker is 4L x 1 1/2inch wide. Any suggestions? Thanks

asked by: Terri E

Expert Reply:

I have a potential solution for you, but there is no gasket made specifically for the Optronics LED Trailer Clearance or Side Marker Light # MCL44RB1.

You could potentially use the Foam Gasket for MC32 Series Lights # A32GB. The MCL32 series measures 4" x 2" instead of the 4" x 1-1/2" that your MCL44 series measures. So you could trim off the extra foam from the height and the wire is located in a different spot so there may need to be some fabrication there as well. But, without there being a gasket made for the MCL44 series, it will require some fabrication on your end.

expert reply by: Scott S