Do I Need an Angled Spacer for the Air Lift LoadLifter 5000 Helper Springs?

Question

Question:

I purchased the 88221 air lift kit for an 89 suburban. It has 4 inch lift blocks in the rear. My question is do I need an angled 4 inch air bag spacer or a flat one?

asked by: Jorge L

0

Expert Reply:

You will need to get under your 1990 Chevrolet Suburban and look at the upper mounting bracket where the Air Lift LoadLifter 5000 Ultimate Air Helper Springs item # AL88221 attaches. If this bracket is angled, like the attached picture, you will need the Air Lift Angled Universal Air Spring Spacers item # AL49GV you referenced. If this bracket is flat then you will need the Air Lift Universal Air Spring Spacers item # AL52440.

expert reply by: Jerred H

0

Lift spacer diagram
(click to enlarge)

Answer 1

You will need to get under your 2016 Ram 1500 with a 6” lift and look at the upper mounting bracket where the Air Lift LoadLifter 5000 Ultimate Air Springs w/ Internal Bumpers item #AL88365 attaches. If this bracket is angled, like the attached…

view full answer...

Answer 2

The Stromberg Carlson Electric Trailer Jack #JET-5000 uses a 12 volt system. The jack will perform better by drawing power from a nearby source rather than through the 7-way wiring harness. I would recommend you use a trailer mounted battery if…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

Hey Ian, great to hear from you again! The differences between the MORryde CRE3000 #MR87ZR and AllTrek 4000 #MR89DR that fit a 33" wheelbase is the height between the hanger and equalizer bolts, and the amount of travel the suspension style will…

view full answer...

Answer 10

If you're wanting to install the Timbren #TFR350SDJ on your 2022 Ford F-350 then you'll want to measure the distance from where your factory bump stops are installed down to the point of contact on the axle. The Timbren #TFR350SDJ are…

view full answer...

Answer 11

Hello Matt, I was seeing some mixed information on this as well, so I reached out directly to my contact at Firestone to confirm. The Firestone Ride-Rite Air Bags w/ Easy Mount Compressor - Wireless Control - Single Path - 5,000 lbs #F44XV will fit…

view full answer...

Answer 12

We sure do Mike! To add a set of air bags and a compressor to your 4WD 2019 Ford F-350, I recommend the Firestone item #F44XV. This kit comes with a set of 5,000 lbs capacity air bags that will level out the rear end of your F-350 when you are towing…

view full answer...

Do I Need an Angled Spacer for the Air Lift LoadLifter 5000 Helper Springs?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching