Is Thread Sealant Needed when Installing Threaded Bearing Buddy

Question

Question:

I am looking to order model number 2080 T-SS-Threaded but I am wondering what thread sealant is recommended to get with that?

asked by: Sam H

0

Expert Reply:

You actually don't have to use a thread sealant with the Bearing Buddies like the part # BB2080T-SS like what you mentioned.

expert reply by: Jameson C

0

Answer 1

Actually all you really have to do is remove the oil from the hub and then pack the hubs with grease and then get the correct bearing buddy to match the threaded hub bore. You will need to measure the inner diameter of where the old grease cap…

view full answer...

Answer 2

In order to pick out the correct bearing buddy you will need know the pilot hole of your hub. To do this, remove the wheel and tire and remove the grease cap from the center of the hub. Usually it is a metal cap that is just lightly hammered into…

view full answer...

Answer 3

Bearing Buddy does specify that the Bearing Buddy Threaded Bearing Protectors, part #BB2080T-SS, will fit the Reliable oil bath unit that has a 2.080 hub bore size and is on many of the EZ Loader trailers. Bearing Buddy recommends using Permatex or…

view full answer...

Answer 4

Reusing your old race is totally fine and going just a little bit past flush with the grease seal is totally fine as well. Normally we recommend flush but if you are just a bit past that there won't be any problems.

view full answer...

Answer 5

According to Bearing Buddy the best grease to use is a high quality, multipurpose #2 grade lubricant. They also recommend not mixing different types of grease. I recommend using LubriMatic #L11465.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Is Thread Sealant Needed when Installing Threaded Bearing Buddy

Product Page this Question was Asked From

Continue Researching