Can Older Race in Trailer Hub Be Reused and Will Grease Seal Installed Past Flush be Okay
Updated 06/17/2019 | Published 06/15/2019 >
Question:
Hello, my first time repacking trailer bearings and I have two questions. The large replacement racing seemed to be a bad fit, bigger but only slightly so I used the new bearing with the old racing. Is that going to cause me any problems? Second, I pushed the grease seal in a couple mm past flush so now its a bit recessed and the large bearing inside has zero play as well the seal itself bent inward slightly, bevelled to the center. Should I replace the seal? Or is it okay to be in there that tightly? Thanks for the help!
asked by: Alex N
Expert Reply:
Reusing your old race is totally fine and going just a little bit past flush with the grease seal is totally fine as well. Normally we recommend flush but if you are just a bit past that there won't be any problems.
Product Page this Question was Asked From
Spindle Grease Seal Set for L44643 Inner Bearing and 1.980 Bearing Buddy
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 1.38 Inch I.D.
- 1.98 Inch O.D.
- Bearing Buddy
more information >
Continue Researching
- Search Results: standard bearings trailer bearings races seals caps
- Q&A: Is Thread Sealant Needed when Installing Threaded Bearing Buddy
- Search Results: trailer light extension
- Shop: Replacement Bearing Buddy Bras - Model 23B - Qty 2
- Shop: Replacement Race L68110 for Bearing L68149 - Qty 1
- Shop: Bearing Buddy Bearing Protectors - Model 2328SS - Stainless Steel - Qty 2
- Shop: Grease Seal - Double Lip - I.D. 1.688" / O.D. 2.332" - Older UFP Hubs/Marine Axles - Qty 1
- Shop: Replacement Trailer Wheel Bearing - L68149 - Qty 1
- Shop: Replacement Bearing Kit with Bearings L44649, Races L44610, Seal 10-9 - Fits 1.063" Spindles
- Article: Most Popular Wheel Bearings
- Q&A: Proper Way to Tighten Trailer Spindle of Castle Nut
- Shop: Optronics Adhesive Trailer Reflector - Stick On - Rectangle - Amber
- Video: Review of etrailer Trailer Bearings Races Seals Caps - Bearing Kit - BK1-150
- Video: Let’s Check Out the Washer For 1" Spindle
- Video: Hands-On with the Grease Seal
- Q&A: Should There Be a Washer on Trailer Spindle Between Spindle Nut and Outer Bearing
- Q&A: What Is The Purpose Of A Spindle Washer
- Q&A: Is a Spindle Washer Needed Between the Spindle Nut and Outer Bearing on Dexter 5 on 4-1/2 Hubs
- Q&A: How to Safely Remove a Bearing Buddy?
- Q&A: How To Tell What Size Bearing Buddy Is Needed for My Trailer Hubs
- Search Results: vintage trailer rims
- Article: VCC Pickup and Dropoff
- Search Results: 10 42 grease seal
- Video: Remove and Reinstall a Trailer Hub Review
- Video: Review of the Bearing Buddy Bearing Protectors-BB1980A
- Search Results: clearance
- Video: Hands-On with the Bearing Buddy Bearing Protectors-BB37SR
- Search Results: 58846 seal
- Search Results: wear sleeve
- Article: Trailer Wiring Diagrams


