Sway Control System for 2018 GMC Yukon with Air Leveling System

Question

Question:

I have a 2018 GMC Yukon Denali with trailer package, which has air leveling on the rear. Do I need a sway kit for pulling a trailer with 4800 pound empty wt and 400 pound hitch wt.

asked by: Glenn A

0

Expert Reply:

2-point sway controls are built into weight distribution systems. A weight distribution hitch is a system designed to create a level, stable ride when you tow a trailer. It will help keep your towing setup level and make sure the weight of your trailer doesn't cause undue stress on your vehicle. I have linked a couple articles about sway control, weight distribution hitches, and the benefits of using these systems.

I recommend the Blue Ox TrackPro Weight Distribution with Sway Control item # BLU47FR. This system comes with a 7-hole shank and is rated for trailers up to 8,000 lbs and a tongue weight of 800 lbs. This system will work great with your 2018 GMC Yukon. The 8,000 lbs capacity of the Blue Ox TrackPro should be perfect for when your trailer is fully loaded.

expert reply by: Jerred H

0

Answer 1

You've done your research! For your towing setup that has a total tongue weight of around 800 pounds I highly recommend the Equal-i-zer Weight Distribution System #EQ37100ET. Your total tongue weight falls right in the middle of its 600 to 1,000…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Hi James! With your GVWR being 7,600 pounds, your loaded tongue weight should be around 760 pounds. With that said, I recommend going with the Weigh Safe True Tow Weight Distribution Hitch - 2" Shank - 6" Drop - 8.5K GTW, 850 lbs TW…

view full answer...

Sway Control System for 2018 GMC Yukon with Air Leveling System

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching