Correct Replacement for Parallax 8355 Converter

Question

Question:

I am looking for a converter/charger replacement for my parallax 8355 with aGM batteries

asked by: Thomas J

0

Expert Reply:

The correct replacement for a Parallax 8355 Converter is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part # PD4655V which works with flooded lead acid, AGM, and gel batteries.

expert reply by: Conner L

0

Answer 1

If your current Voyager WiSight system is the 1.0 version and not the 2.0 version then you would need to replace both the camera and monitor since the 1.0 parts have been discontinued and are not compatible with the 2.0 system #ASA57YR. Voyager made…

view full answer...

Answer 2

Hello Bob, thanks for reaching out. Unfortunately there is not a camera available that is compatible with the Voyager WVOS54 monitor. This is an older first gen camera system and they have been discontinued so we do not have a compatible camera. The…

view full answer...

Answer 3

it sounds to me like your Furrion convection oven either has a bad heating element or temperature sensor. You can have a qualified technician check both as well as the gas pressure to ensure that you're getting 11" WC so that the oven can…

view full answer...

Answer 4

Hey Mike, great question! I reached out to Dometic and they said the Dometic Soft Start for FreshJet Mechanical Air Conditioners #DMC87RR is also compatible with the FreshJet 5. You can use this to add a soft start to your new AC unit. Any big trips…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Correct Replacement for Parallax 8355 Converter

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching