What is the Post on the Optronics LED Clearance or Side Marker Light Made From

Question

Question:

I Know the back plate is stainless steel, but is the mounting stud/nut stainless steel too? Picture doesnt look like it. Thanks

asked by: Corey M

0

Expert Reply:

I was able to confirm with my contact at Optronics that the mounting post on the # MCL95AB is stainless steel, but the mounting hardware is not.

expert reply by: Erik B

0

Answer 1

Yes, all of the lights in the #TL16RK Waterproof, Over 80 inch Trailer Light Kit will need to be grounded. The white wires on the tail lights are attached to the trailer frame, and the chrome bases provide the ground to the trailer frame through the…

view full answer...

Answer 2

Each lamp needs to be grounded either through its mounting studs being in direct contact with the trailer frame or by having a jumper wire ran from the lamp to the trailer frame. Ground the trailer connector at the front of the trailer, which will…

view full answer...

Answer 3

The bolt on the back of the clearance light #MCL95AB is approximately 5/8 inches long from the back of the light housing to the end of the bolt. Not all bolts on lights equipped with them are the same length but they are generally within very close…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

What is the Post on the Optronics LED Clearance or Side Marker Light Made From

Product Page this Question was Asked From

Continue Researching