Tip for Installing Replacement Jet Nozzle for SewerSolution Macerator System
Updated 05/13/2025 | Published 07/22/2021
Products Featured in This Question
Question:
I had the sewer pump cracked after just 2 uses, stored in RV so was think heat might have gotten to it. Ordered a new pump but how the heck do I get it inserted into the hose, I have tried leaving it in sun to soften the hose, tried hair dryer. How can I get it inserted?
asked by: Barbara C
Helpful Expert Reply:
Make sure the band clamp of the # SS01 is totally loosened and slid back off of where it would need to slip over the nozzle of the # 278-2204. You can put some dish soap on the nozzle as well to help it slide into the hose which is a tight fit. Try that and see if that helps.
Product Page this Question was Asked From
Replacement Jet Nozzle for SewerSolution Macerator System
- Accessories and Parts
- RV Water Pump
- SewerSolution System Parts
- Pumps
- SewerSolution
more information >
Continue Researching
- Shop: Replacement Jet Nozzle for SewerSolution Macerator System
- Shop: SnapPad XTRA Square 5Jack Pads for Lippert Leveling Systems - 5-1/2" Square Feet - Qty 4
- Shop: RV Jack Pads
- Search Results: toilet paper
- Search Results: rv toilet paper
- Search Results: dometic refrigerator parts
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Search Results: trailer tires and wheels
- Shop: Trailer Wiring
- Search Results: trailer jack
- Article: How to Measure for Trailer Hitch Drop
- Video: How to Choose a Trailer Brake Controller
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Suspension Enhancement
- Shop: Brake Controller
- Search Results: trailer wiring
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Shop: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Way Coiled Adapter Cord
on Accessories and Parts
Jeffrey
5/11/2025
Thanks for the advice about dish soap. Last one I installed the metal "pipe" came unglued when I was installing the replacement jet nozzle onto the hose. Would it help if I used a tubing heater to soften th hose a bit. Once that inlet pipe comes loose it leaks. p.s. got my replacement from e-trailer!