Does Stromberg Carlson A-Frame Trailer Jack SC63VR Use Ball Screw Mechanism

Question

Question:

does the SC63VR use a ball screw type mechanism?

asked by: Rick S

0

Expert Reply:

It sure does! I checked with the manufacturer, Stromberg Carlson, for you and they verified for me that a ball screw mechanism is indeed used on the 4,500 lb A-Frame jack you asked about, which is the following part number:

- Stromberg Carlson Electric Trailer Jack # SC63VR

That was a good question because a jack with a ball screw mechanism is definitely the best option as they are the most efficient, durable type of trailer jack.

expert reply by: Kyle S

0

Answer 1

If your Husky Brute Electric Trailer Jack is only making a clicking noise and you have checked the power source there are a couple of other issues that may be occurring. Start by checking your ground connection to ensure it is secured to a clean,…

view full answer...

Answer 2

I do have several replacement parts available for the RAM Trailer Jack part #TJD-7000S but not an all inclusive rebuild kit. Instead you will need to select from the components listed below and repair the jack as needed. The most common fault on the…

view full answer...

Answer 3

Hey Don, yes the Stromberg Carlson electric jack part #JET-3755 that you referenced would be a great option to replace the Lippert Smart Jack you have now. It uses the same mounting bracket bolt pattern so it will install easily and is a lot simpler…

view full answer...

Answer 4

Thread damage to the screw/nut inside of a jack is usually a result of over extending the trailer jack. I'm not saying that is what happened to you but that is the cause of the majority of these situations. Is your jack still covered under…

view full answer...

Answer 5

Hi Doug; we don't have a cover specific to those jacks but you can use the etrailer Protective Cover for Electric A-Frame Jacks #e27VV. This is a weatherproof cover with polyvinyl fabric construction and a drawstring to cinch around the bottom.…

view full answer...

Answer 6

If your Husky Brute 4500 isn't extending or retracting properly then I recommend using the manual override to see if it's something internal or if it's an electronic part of the jack. For a replacement electrical part you'll need to…

view full answer...

Answer 7

Hey Fred, I am very sorry to hear that your trailer jack keeps blowing fuses. If your Stromberg Carlson Jack #JET-3755 keeps blowing the 30A fuse, there are a few things to check that might help figure out the issue. First, take a look at the wiring.…

view full answer...

Does Stromberg Carlson A-Frame Trailer Jack SC63VR Use Ball Screw Mechanism

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching