Installation of Brake Buddy Supplemental Braking System on 2014 Honda CR-V
Updated 06/14/2021 | Published 06/10/2021
Question:
Trying to figure out where to drill a hole in firewall of 2014 Honda CR V for the power harness to battery . Is there a measurement from a fixed point inside on firewall to drill a hole for the harness to go through . There are brake lines and brake booster on the engine side of firewall . Thanks
asked by: Thomas W
Expert Reply:
For installation of your Brake Buddy, # HM39524, you can route the wires through a grommet that is already being used for the factory wiring. I suggest you look underneath the brake fluid reservoir to the driver's side to locate a good option; push your wiring through here then use a pull from inside the cab of the vehicle. I have attached a couple of installation videos that will hopefully assist you.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Vehicle Tow Bar Brake System
- Shop: Vehicle Tow Bar Wiring
- Shop: Base Plate for Tow Bar
- Q&A: Installation of Hopkins Custom Tail Light Wiring Kit for Towed Vehicles on 2008 Honda CR-V
- Q&A: Parts Needed to Flat Tow a 2007 Honda CR-V Behind a Motorhome
- Q&A: Is Brake Light Relay Required When Using Hopkins Tail Light Wiring # HM56300 in 2010 Honda CR-V
- Q&A: Recommended Flat Towing Wiring Harness for a 2013 Honda CR-V
- Q&A: Why Would Hopkins Tow Bar Lighting Kit for 2010 Honda CR-V Prevent Taillights from Working
- Q&A: Difference Between Hopkins # HM56300 and Tow Ready # TR118821 Flat Towing Wiring for 2010 CRV
- Video: How to Set Up Your Hopkins Custom Tail Light Wiring Kit for Towed Vehicles on a 2010 Honda CR-V
- Video: All About the Hopkins Custom Tail Light Wiring Kit for Towed Vehicles
- Search Results: roadmaster base plate
- Search Results: roadmaster diode 7~wire to 6~wire flexo~coil wiring kit
- Search Results: falcon 2
- Search Results: hopkins flat tow wiring harness
- Search Results: tow bar base plate
- Search Results: rm88400
- Search Results: brake light relay
- Shop: Roadmaster Brake-Lite Relay Kit for Towed Vehicles
- Shop: LCD Digital Circuit Tester
- Shop: etrailer Invisible Base Plate Kit - Removable Arms
- Shop: Curt Custom Tail Light Wiring Kit for Towed Vehicles
- Shop: Hopkins Custom Tail Light Wiring Kit for Towed Vehicles
- Shop: Curt Universal Tail Light Wiring Kit for Towed Vehicles - 4-Way Flat Connectors
- Shop: Pollak Heavy-Duty, 7-Pole, Round Pin, Trailer Wiring Connector - Trailer End
- Video: DIY 2014 Honda CR-V Installation for the Brake Buddy Stealth Supplemental Braking System
- Video: Hopkins Custom Fit Vehicle Wiring - Trailer Hitch Wiring - HM11143145 Review
- Article: Trailer Wiring Diagrams
- Q&A: Installation Instructions for Brake Buddy Select 3 Braking System