Replacement Brackets For Curt TruTrack Weight Distribution C17500

Question

Question:

Is it possible to just buy the L brackets? I think the dealer installed incorrectly on the new trailer. They bent...I just need the L bracket portion for this particular system but I can only find the full assembly.

asked by: TODD S

1

Helpful Expert Reply:

The frame brackets are available as a replacement part for the Curt TruTrack Weight Distribution System # C17500, but just the "L" portion of the bracket is not sold individually, so to replace that portion you would need the frame bracket assembly:

- Replacement Frame Brackets for Curt TruTrack Weight Distribution System # C17508

expert reply by: Kyle S

1

Answer 1

Based on your photo, the system was not setup correctly so the bars that should be applying friction to the brackets evenly is only hitting on that inside edge of the bar. That will not carry the weight correctly and definitely can cause scary sway.…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

Using the cut off wiring harness you have for the P3 part #90195 you will wire it to the brake controller wiring of your 2023 Ford Ranger which is sticking out of the large wire harness that goes through the driver's side firewall, left of the…

view full answer...

Answer 7

The best hitch for your 2023 Ford Ranger is going to be the Curt Hitch item #C13417. This hitch is custom fit and bolts to your Ranger with included hardware. I really like the Curt hitch because it installs behind your rear bumper and the crossbar…

view full answer...

Replacement Brackets For Curt TruTrack Weight Distribution C17500

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching