How To Mount a Toolbox On a Truck With Thule TracRac Sliding Ladder Rack

Question

Question:

I am looking for truck tool box that works with 2003 silverado tracrac

asked by: John S

0

Expert Reply:

In order to mount a crossover style tool box on a truck with Thule TracRac Sliding Ladder Rack you will need an adapter, the Toolbox Mounting Kit for Thule TracRac SR, Utility Rac, and G2 Sliding Ladder Racks part # TH25200. This will then allow you to use pretty much any crossover style toolbox such as the UWS Truck Bed Toolbox part # UWS07642 which is what I recommend because of the low profile design.

expert reply by: Conner L

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 5

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 6

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 7

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 8

Hey Daniel congrats on the new truck! The Lomax Stance Hard Tonneau Cover item #LOM54RV does indeed fit the 2026 Chevrolet Silverado EV with the Mid Gate. It also works with the Multi-Flex Tailgate that comes on the Trail Boss models. For a…

view full answer...

Answer 9

Thanks for the pictures Mike! The Trailer Mate Hitch item #TMT59FR will indeed fit your 2020 Ford F-150 without a factory hitch. The hole in the bumper and the two holes in the brackets will not be used in the installation though. The hitch attaches…

view full answer...

Answer 10

Hello Joe, Thanks for writing in! Based on the measurements you provided, the Gen-Y Glyder Shock Absorbing Ball Mount #325-GH-12001 is not the right fit for your setup. Since your Tundra's receiver measures 18 inches from the ground and your TAB…

view full answer...

Answer 11

Hey Mike, I have an over the cab style of ladder rack that fits your 2005 Toyota Tacoma with the Malone TradeSport/OverPass part #MAL73HR but the Erickson you referenced does not fit your truck. What are you planning on carrying with it?

view full answer...

Answer 12

Hey there Steve; thanks for writing in and when it comes to body roll and sway for your 2018 Ford F-150, the better option is the RoadActive Suspension Custom Leaf Spring Enhancement Kit, with the right one depending on if your F-150 is 2WD or 4WD: -…

view full answer...

How To Mount a Toolbox On a Truck With Thule TracRac Sliding Ladder Rack

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching