Will Kodiak Disc Brake Caliper Work With Trailer Surge Brake System

Question

Question:

Hello Will these kodiak calipers work with a surge brake system or do I need special surge calipers to work with my system. Thanks.

asked by: Brendan L

0

Expert Reply:

The Kodiak Disc Brake Caliper # KDBC225DAC is designed to be used with a surge brake system so yes, it will work with your trailer setup. Just make sure that your axle is rated for 3,500 - 6,00 lbs,that your rotor diameter is 10" or 12", and that the caliper mounting flange bolt holes measure 5-3/4" on center where the caliper will be installed.

Attached is a review video for you to check out.

expert reply by: Jon G

0

Answer 1

Hey Tim! Are you looking for slip-on rotors like the #DE82FR you were looking at? The 7k disc brakes fit the same brake flange so you can use them with your setup. The correct kit depends on your wheel bolt diameter. If you have 9/16" wheel…

view full answer...

Answer 2

Hey Adam, so you don't need to verify any dimensions to make sure the Kodiak disc brake assembly part #K1HR35S fits your axles. This was designed to fit the standard spindle/brake mounting flange that your trailer would have since the DeeMax kits…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Will Kodiak Disc Brake Caliper Work With Trailer Surge Brake System

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching