Replacement Circuit Board for MaxxAir Roof Vent 4900K

Question

Question:

Do you carry replacement circuit boards for maxxair model 4900K?. Serial # is2011-12-4900k-0570. Also will the 6 button wall mount remote work since my remote only has 5 buttons exhaust only?

asked by: Pierre E

1

Helpful Expert Reply:

I've had this same question before and when I reached out to MaxxAir they told me that the correct circuit board replacement for the 4900K is the part # MA10A21275K.

expert reply by: Jameson C

1

click to enlarge

Answer 1

The correct replacement motor for a Ventline Vent Fan V2094 is the Replacement 12V DC Motor for Ventline, Ventadome part #BVD0218-00.

view full answer...

Answer 2

I've attached the owners manual for your 4900K model which is similar to the #MA00-04500K model. It sounds like your operator mechanism is bad according to my tech contact at MaxxAir. For your 4900K model you will want the Replacement Operator…

view full answer...

Answer 3

The first step to bleed the brakes is to have the Carlisle HydraStar Electric-Hydraulic Actuator #HBA16 activate so that hydraulic pressure is being made in your brake system. You can do this by having somebody step on your tow vehicle brakes while…

view full answer...

Answer 4

The instructions may vary depending on the brand of the electric-over-hydraulic (EOH) actuator but for the HydraStar actuators, like part #HS381-8067 that you referenced, it basically boils down to using the bleeder screw and the brake controller on…

view full answer...

Answer 5

I spoke with my contact at MaxxAir regarding your vent like the MaxxFan #MA00-04500K. He said what you are experiencing might be caused by a short in the rain sensor. Since that light is coming off and on, this is likely the issue and what is also…

view full answer...

Answer 6

The correct circuit board for your MaxxAir MaxxFan 4951KS fan is the Replacement Printed Circuit Board for MaxxAir MaxxFan Plus Roof Vents #MA10A04751KS. It also works with The MaxxAir MaxxFan 4751KS and 4761KS models as well.

view full answer...

Answer 7

We do not carry an exact replacement unit for the MaxxAir Deluxe 8951K. We have the Smoke #MA00-07500K or White #MA00-07000K which would be the closest replacement. These fans use the same lift and fan motors but the control panels and circuit boards…

view full answer...

Answer 8

Thanks for the picture! Based on what you are describing it sounds like the leak is coming from the motor. There wouldn't be anything that would leak out of the operator mechanism. We have the Replacement 12-Volt Variable Speed Fan Motor for…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Replacement Circuit Board for MaxxAir Roof Vent 4900K

Products Featured in This Question

Continue Researching