Replaces the printed circuit board for your MaxxFan RV roof vent with powered lift and reversible fan. Works with both aftermarket and OEM models of MaxxFan Plus and MaxxFan Deluxe manufactured after 2010.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Michael: Hi there. I'm Michael with etrailer.com. Today, we're going to take a quick look at the replacement printed circuit boards for your max air powered lift RV roof vents. As you can see, we've got two different boards here. These are the part numbers that you see on the screen there. Essentially, these are exactly the same thing with one small difference between them.
If you look at the circuit board, you can see they have almost all of the same components except this large black box here. This is actually going to allow you to work. Allows this board to work for your max air vents that are both exhaust and intake. So this other one that does not have that box is only going to work with your max air fans that are exhaust only. If your unit is able to bring air in as well as exhaust it out, you're going to need this one over here.If your unit is only capable of exhausting the air from inside your RV, this is the unit that you will need here.
Keep those part numbers up there for you to make sure that you are getting the right one. It's a pretty slight difference between them, but obviously it's going to have a big impact on their usability. We want to make sure that you're getting the product that you need, so just wanting to clear that up for you. Both of them are going to work with your max air power. It's just that functionality difference that you need to look out for.
We're going to make sure that you knew the difference and are going to get the right chip that is going to work for you. That is going to complete our look at the max air replacement printed circuit board. Again, I'm Michael with etrailer.com. Thanks for watching.
Average Customer Rating: 4.5 out of 5 stars (130 Customer Reviews)
Replaces the printed circuit board for your MaxxFan RV roof vent with powered lift and reversible fan. Works with both aftermarket and OEM models of MaxxFan Plus and MaxxFan Deluxe manufactured after 2010.2 of my 3 MaxxAir fan had the green light of death. Long story short one of the replacement boards worked while the other replacement board did not fix the green death. Extremely frustrating that this needed to be done to brand new fans in the first place and I still have an issue with one of the fans. Not etrailers fault but I wouldn’t recommend a MaxxAir fan to anyone.
This was a great solution for the “green light of death” on our MaxxAir Fan. It was easy to install and worked immediately. The order arrived safely and on time. The price was good value.
I had called MaxxAir and asked about getting this part to fix a flashing Green light on one of the fans that I have in my 2012 Aspect. They quoted me a price of $116.40 plus tax and shipping but they were out of stock and delivery probably would not happen for 2-3 weeks I was told. I have ordered parts from trailer.com before and had always received fair pricing, quick delivery and good customer service. I placed my order - the cost was $136.17 (about $20 more than direct from the manufacturer), Sales tax (7%) is based upon the delivery address and shipping was free from trailer.com (a savings of $9.67). So, I paid about $10 more overall than had I gone direct. However, I received the control board in just over 4 days from Utah to South Carolina and IT WORKED. My Maxx Air fax is now working properly again. I'll continue to purchase from etrailer.com. I recommend you give them a try on your next order.
Carol;
Thank you for the prompt email regarding the circuit board replacement for my MaxxAir Roof Vent. I must say that etrailer customer service has been fantastic with regards to this item. I completely understand that the lengthy delay in obtaining the item was the fault of MaxxAir and not etrailer. Your customer service regularly kept me informed of the manufacturer's shipping progress and it was very much appreciated. Anytime in the past I have ordered from etrailer I have received excellent service and this time was no exception. Thank you and your team again for the outstanding customer service.
Sincerely,
Roman
I think the circuit board should not go bad after 2 years the new one cost almost half of what a whole new fan cost. But that's maxair, you guys do a great job. But But But stop putting electronics in a envelope all the little circuits where bent I'm just lucky it worked. Thank for getting it out so quick.
Although I purchased this device almost a year ago, I wasn’t able to install it until recently. Unfortunately, this device developed the same fault as the one that it replaced. After just a few minutes of use, the fan stopped working, beeped loudly, and flashed its LED.
I would have given 5 stars but the circuit board had some damage to it and was doubtful it would work but it worked just fine.
Perfect replacement. Install was no problem and it worked with the existing remote immediately. Its just a shame MaxxAir let their circuit board problems go on so long.
I installed the new PC board in less than an hour. It works. I hope it continues to work. Time will tell. Maxxfan should have installed a more dependable PC board. Other Maxxfan customers have complained about the fan starting and stopping on it's own. The PC board the apparent problem with shorted circuits. Fingers crossed.
They shipped out immediately and was exactly what I needed. They need to stop sending this in an envelope though as the pins for the connection to the fan get bent.
Even though a supply train issue delayed receiving my part for 4 months, etrailer always kept me informed of the shipping status. This up level replacement MaxxAir PC board and it worked with no problems. It eliminated the so called "green light of death". Great job guys!
Fantastic Customer Service Dept!!!!!
The product arrived way in advance of the expected date which was beneficial. Also it arrived in great condition and worked perfectly!
After being told they wouldn't get one in stock till July, all of a sudden it was delivered today. I was able to install it myself and it actually works.
Haven't installed yet Just ordered as a back up Quick shipping
I’m impressed and appreciative that you’re reaching out about my thoughts on my purchase, but sadly it did not solve my problem with the “green light of death”. Pinpointing the problem has been a real challenge. I’ve changed power sources (GoalZero, Jackery and lead acid) as well as adding a voltage regulator with no change. If you have any ideas on what it might be I’d be very thankful. But getting back to your question, i don’t think I can give a proper rating.
Part worked as described and we had air flowing again in the RV!
I really like the search engine on the website. I quickly found the circuit board for the Maxxfan that I needed. The people I dealt with were very knowledgeable and helpful.
Just what I needed. It worked. Good service. Fair price.
You guys have been great. I ordered this part back in June due to the supply chain problems it wasn't going to come in anytime soon. There was one gentleman that always kept we in the loop of where my part was. I am sorry I don't remember his name just a great guy. I would have no problem ordering from these guys again Thanks
Worked well and solved my problem. Service and shipping were excellent.
I have been looking for this part for over a year and finally found it at your website, you gave me enough information to be sure this was the right part and also great support, thanks so much
it dosen't work with are remote
Circuit board was delivered wrapped in bubble wrap but inside a pouch NOT a box.
Of course the pouch had a hole punctured in it. So it could be damaged??
I dont know though as my fan is now working again(intermittant failure) and Im not going to replace the board until it fails again.
As it is I do not know if the new board that arrived in a damaged package actually still works.
Sensative parts should be sent in a box.
Why does this even need to be said?
Looks and works great
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.