View Cart

Dutton-Lainson Trailer Jack - Side Frame Mount Jack - DL22800 Review

content loading



Customers compare DL22800 to these similar products




Products Featured in this Video



Review of Dutton-Lainson Trailer Jack DL22800


Today we'll be taking a look at part number DL22800. This is the Dutton Lainson pull pin, easy swivel, trailer jack, rated at 1500 pounds. This is a bolt on install. All the mounting hardware that you need is included with this purchase. This is going to provide roughly about 10 inches of lift. The enclosed outer tubing is going to help prevent sand and dirt from contacting the minor gears and the heavy duty acme screw on the inside.

This is going to fit square tongues up to 3 inches wide, by 5 inches tall, and once again, all the mounting hardware is included. Here on the outside, our outer tube is going to measure 2.25 inches in diameter. Our inner tube is going to measure 2 inches in diameter. This jack has floating miter gears that allow for proper clearance and easier operation. It also provides maximum maneuverability from the offset swivel caster assembly, and the wheel is going to be an 8 inch wheel. This has a really nice zinc plated finish that's really going to help it stand up nicely to rust and corrosion.

We have our ergonomic hand grip here on top, with a textured surface that's going to provide smooth operation when cranking. It's also going to give us a handle radius of about 6.5 inches. Now, overall, from the bottom of the wheel to the top of our jack, we have an overall length of about 26 and 3/8's of an inch. From the mounting plate, to the top of our jack .. I'm measuring from the center of the mounting plate to the top of our jack, we're going to have a measurement of 13.5 inches.

With this in it's fully retracted position, from the bottom of the wheel to the center of our mounting plate, we're going to have a measurement of about 13 inches. I have another jack here that is fully extended. If we measure from the bottom of the wheel to the center of the mounting plate, we're going to have a measurement of about 23 inches. If we subtract those two measurements, that's going to leave us with 10 inches which is where we're going to get our left measurement from. Here on our mounting plate, we have a nice pull pin function that once we pull that, it's going to allow our jack to move either up into a stored position or back down into an upright position to support and life our trailer. It has four different holes that it's going to pop into.

That way, you can rotate your jack as needed to best suit your application and the desired position that you're looking for. That's going to complete today's review of part number Dl22800. This is the Dutton Lainson pull pin, easy swivel trailer jack, rated at 1500 pounds. .


Questions and Comments about this Video

add comment

Info for this part was:

Video Edited:
Zack K
Installed by:
Cole B

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.