Trailer Jack with 1,500 lb Capacity for 2 inch Trailer Frame

Question

Question:

Do you have something similar in higher quality? Needs to fit 2inch trailer frame, and the seems like the value and premium upgrades were for 3 inch or larger. Thanks, please advise. Round Swivel Marine Jack w/ Wheel - Bolt On - Zinc - Sidewind - 11inch Travel - 1,500 lbs Item # MJ-1500B

asked by: Mike

0

Expert Reply:

While the cost of the Round Swivel Marine Jack # MJ-1500B is relatively low it still is a quality trailer jack. We get a special price on this since it's our house brand of jack but it will function and last just as long as the other more expensive trailer jacks. This also fits a 2 inch trailer frame like you have so in that regard it would work great for you.

expert reply by: Jameson C

0

Answer 1

For your 2.5 inch wide and 2 inch high trailer tongue, the Round Swivel Marine Jack w/ Wheel - Bolt On - Zinc - Sidewind - 11" Travel - 1,500 lbs #MJ-1500B is my recommendation. It will work very well with the trailer tongue you have and will…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Hi Ron! To get the 12v power port on your 7-Way working, you will want 12 gauge wire and a 40 amp circuit breaker (I have both listed below). This will get you needed power and protection for your Curt Echo Wireless Brake Controller #C51180. 12 Gauge…

view full answer...

Answer 6

The Hopkins 5-Way Flat Connector #HM47913 you referenced has a 18 gauge wire for all but the ground wire, which is 16 gauge.

view full answer...

Answer 7

The CE Smith Bolster and Swivel Bracket part #CE10000G that you referenced certainly could replace the rusted out brackets on your trailer. This product is designed for doing what you are looking for so it would work well. I attached a review video…

view full answer...

Answer 8

Hey Brian! Yep, for your boat trailer, I’d skip the etrailer A-frame drill jack #e38AV since your trailer doesn't have that standard 3-bolt A-frame jack mount. That could be fabricated to fit, but that's a lot of unnecessary work. For a…

view full answer...

Answer 9

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…

view full answer...

Answer 10

Hey Brian, thanks for reaching out. I went out to our warehouse and measured one of the etrailer Sidewind Aluminum Jacks #e95YV. The distance from the center of the bracket to the bottom of the wheel is approximately 14" with the jack fully…

view full answer...

Trailer Jack with 1,500 lb Capacity for 2 inch Trailer Frame

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching