Is the Red Light Constantly on with the Fan-Tastic Vent Roof Vent

Question

Question:

Fan operates fine, but there is a red light on the rim that stays on. Is that normal?

asked by: Tony C

1

Helpful Expert Reply:

Yes the Fan-Tastic Vent Roof Vent w/ 12V Fan and Remote part # FV807350 does have a small led that stays lit indicating power.

expert reply by: Randy B

1

Answer 1

Thanks for the photo, that was a huge help! You're needing 1/2 inch wire loom, which we sell by the foot as part #459075-1. I'd also use some 1/2 inch loom clamps, part #A0500 to secure the wire loom and hold it where it's supposed to…

view full answer...

Answer 2

The Dexter Trailer Brake Assemblies 023-466-00 and 023-467-00 will cross-reference to our Dexter Nev-R-Adjust Electric Trailer Brake Kit part #23-458-459.

view full answer...

Answer 3

It sounds like you are looking for a new motor for an RV slide out. I checked with my contact at Lippert Components, which makes the majority of OEM trailer and RV frames and slide-outs, and they do indeed have a direct replacement motor. You will…

view full answer...

Answer 4

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Is the Red Light Constantly on with the Fan-Tastic Vent Roof Vent

Continue Researching