Replacement 4.80-4.00-8 Tire for Log Splitter

Question

Question:

If my tire says 4.80-8 will the Kendra loadstar K371 tire 4.80-4.00-8 fit it? It is for a log splitter.

asked by: Jacqueline P

0

Expert Reply:

Yes, the Kenda part # AM1002 will fit as a replace the 4.80-4.00-8 tire size you have on your log splitter.

expert reply by: Jameson C

0

Answer 1

In the 4.80-8 tire size you specified we offer a number of pre-mounted bias-ply-type trailer tire-with-wheel combinations in several load ranges and wheel bolt patterns. The link provided will take you to our page for all available items where you…

view full answer...

Answer 2

The size 400/480 and 4.00/4.80are the same tire size. The 400/4.00 designation referrers to an older tire size that is no longer available and the 480/4.80 size will replace the older model sized. Therefore, a tire like the Kenda Bias Trailer Tire,…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Answer 12

Hey Clarence. There's no way to look at a tire or wheel and tell if it's a 5 on 4-1/2 or a 5 on 5 but you can take a real quick measurement to figure it out. If you'll look at the picture below you'll see a wheel with a red line on…

view full answer...

Replacement 4.80-4.00-8 Tire for Log Splitter

Product Page this Question was Asked From

Continue Researching