Lippert Rear Stabilizer Model 201353 Shear Pin Replacement

Question

Question:

My pin sheared on the stabilizer motor and I am wondering if I can order just a pin and what would be the model number or size I need?

asked by: Aaron

0

Expert Reply:

I contacted Lippert Components to ensure we get you the right pin and they said that there are two pins located right by each other there at the motor. These should both be replaced. The larger one Replacement 5/32" x 1" Roll Pin for Lippert Components Stabilizer Jacks part # LC125462 is the one slightly closer to the motor and the smaller Replacement 3/32" x 1" Roll Pin for Lippert Components Stabilizer Jacks part # LC181003 is located about an inch closer to the middle of the camper. Replace these and you will be back up and running, Happy Camping!

expert reply by: Randy B

0

Answer 1

Per the manufacturer when it comes to the shear pins being broken you would have to replace the whole Lippert Jack #LC298707 because the shear pins are not replaceable, and there is no way to fix them. What you will need to do is purchase a whole new…

view full answer...

Answer 2

The mounting hole spacing is 68-11/16" from center-hole to center-hole for the Lippert Components High-Speed Power Stabilizer Jack - 30" Lift #LC369774. This stabilizer is the same unit used for the other Lippert stabilizers we carry that…

view full answer...

Answer 3

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 4

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

We have had a similar question to this come up and we were able to determine that the number AS-13 M-VDO449 that you listed is stamped on the vent cover part #BVD0449-A01. If you are looking for the entire fan setup and not just the cover you would…

view full answer...

Answer 7

We have actually spoken with Ventline regarding your model AS-13 M-VD0449 in the past and they have confirmed that the correct replacement cover is the part #BVD0449-A03 in Smoke or #BVD0449-A01 in White. The cover measures 14 inches x 14 inches and…

view full answer...

Lippert Rear Stabilizer Model 201353 Shear Pin Replacement

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching