Can the Leveling Scissor Jack Set Be Used On a Class C Motorhome

Question

Question:

Can this product be used on a class C motorhome? Ig so, where would they be mounted?

asked by: Angela J

0

Expert Reply:

The Leveling Scissor Jack Set part # JSC-24 can be mounted on a motorhome yes. In regards to installation, the jack will need to be attached to a part of the frame but there aren't many other mounting restrictions. However, I do recommend you check your ground clearance once mounted so you don't have any issues with them scraping. That said, please note the above jacks only offer up to 24" of lift so if you need more than this then you will have to go with the Leveling Scissor Jack Set part # JSC-30 which offer up to 30" of lift.

expert reply by: Conner L

0

Answer 1

We have scissor jacks that will work for you, just keep in mind that scissor jacks are only designed to stabilize a portion of your weight as opposed to the full 15,000 lbs. The scissor jacks with the largest capacity are the Ultra-Fab Ultra Scissor…

view full answer...

Answer 2

I was able to find the dimensions of the Leveling Scissor Jack Set - 30 Lift - 10,000 lbs #JSC-30 you were looking at as shown in the included diagram, but unfortunately Stromberg Carlson does not have any CAD or technical drawings of the jacks. The…

view full answer...

Answer 3

Considering the weight of your 24 fot Class C RV these Leveling Scissor Jacks, part #TJSCHD-24, should work very well for you. As far as the stability of these jacks, like you said, you will want to have the wheels blocked so that if the jacks are…

view full answer...

Answer 4

Tri Pods do give you a major boost in stabilization, but a system like the JT Strong Arm Stabilizer Kit #LC191025 will be much more stabilizing. Why? Well you are taking your current jack and adding two separate components, creating a larger spread…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 9

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 10

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

Can the Leveling Scissor Jack Set Be Used On a Class C Motorhome

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching