How to Fix Hazard Flashing Activating Brake Controller and Brakes
Published 10/25/2019
Question:
90 Ford diesel with a Voyager brake controller, when the hazard lights are turned on the brake controller activates in sink with the hazard lights.
asked by: William R
Expert Reply:
This is not an uncommon issue, since the Tekonsha Voyager Brake Controller # 39510 is wired in behind the stop light switch, it is activated by the brake light signal. The worst part occurs if you have the gain turned all the way up and you experience some brake pulsing when this happens- which can be especially fun.
To eliminate that from occurring you will need the Draw-Tite Pulse Preventer, part # 5501. The Pulse Preventer will isolate the brake controller from the vehicles flashers. This part will install where the brake controller is spliced into the wire from the cold side of the stoplight switch. This is typically the red wire on the brake controller.
Find the spot where the brake controller is spliced into the wire from the cold side of the stoplight switch. Then just past this (away from brake controller) cut the vehicle stoplight wire and install the Pulse Preventer inline with the yellow wire on the side that the stoplight switch and brake controller are on and the brown wire on the side going to the vehicles brake lights. This connection will stop the hazard signal from feeding back to the brake controller, eliminating the pulse problem.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: flat tow wiring harness
- Search Results: air over hydraulic brakes flat tow brake system
- Search Results: bulb and socket kit flat tow wiring harness
- Search Results: air brakes flat tow brake system
- Search Results: blue ox breakaway switch
- Search Results: blue ox tow bar
- Search Results: roadmaster rock guard
- Shop: Vehicle Tow Bar Brake System
- Shop: Base Plate for Tow Bar
- Shop: etrailer Invisible Base Plate Kit - Removable Arms
- Shop: Roadmaster Direct-Connect Base Plate Kit - Removable Arms
- Shop: Roadmaster BrakeMaster w/ Pressure Reducer for RVs w Air or Air-Over-Hydraulic Brakes - Proportional
- Shop: Vehicle Tow Bar Wiring
- Shop: Suspension Enhancement
- Q&A: Parts Needed to Flat Tow a 1999 Jeep Wrangler Sahara
- Shop: Blue Ox Alpha Non-Binding Tow Bar - RV Mount - 2" Hitch - 8,500 lbs
- Shop: Roadmaster Guardian XL Rock Shield for Direct-Connect Baseplates
- Shop: Roadmaster Guardian Rock Guard for Towed Vehicles - 2nd Vehicle Kit
- Shop: Roadmaster Tow Bar Adapter Brackets for Demco Classic Base Plates
- Video: An In-Depth Look at the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Shop: Towing Mirrors
- Shop: Ladder Rack
- Shop: Headache Rack
- Q&A: What Front-Axle Timbrens do You Recommend for My 1990 GMC Jimmy?
- Q&A: Pulse Preventer for Draw-Tite Activator Trailer Brake Controller
- Q&A: Is There Still a Pulse Preventer for Electric Trailer Brake Controllers
- Q&A: Protecting Tekonsha P2 Brake Controller
- Q&A: Recommended Pulse Preventer For Electric Brake Controller To Prevent Brake Pulse From Turn Signal
- Q&A: How To Install Pulse Preventer On Vehicle with Factory Brake Controller Port
- Article: Trailer Wiring Diagrams
on Trailer Brake Controller
