How Many Load Resistors Are Needed When Installing LED Turn Signal Bulbs on 1993 Silverado
Published 10/11/2019
Question:
I hope you can help me I got a 93 Chevy Silverado C 1500 I want to put LED bulbs on so I got two turn signal bulbs per side ?? theres three wires per socket wired together three wires from the harness that feeds the two bulbs the question is do I need 2 resistors in the harness or resistor at both bulb sockets I hope you can help thank you for your time Jr
asked by: Jr
Helpful Expert Reply:
To prevent hyperflashing with the new LED bulbs on your 1993 Chevy C1500, you will need to add a single Diamond LED Load-Resistor # DI34ZR (which includes two resistors) to each turn/blinker circuit on the truck. If the same circuit wire is feeding into the two bulbs on each side of the truck, you should only need one resistor on each side, in-line with the circuit before the bulb (for a total of two).
If each individual turn signal bulb is fed by it's own circuit wire though, you would need to add one for each bulb (for a total of four).
I have attached the written installation manual that you can look through as well.
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Continue Researching
- Shop: Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Video: All About the Load Resistor Kit for LED Turn Signals
- Shop: Optronics Load Resistor for LED Lights - Male PL-3 Plug and Female PL-3 Plug - Qty 1
- Shop: Trailer Wiring
- Video: A Closer Look at the 7-Way Trailer Adapter for Towing Trailers with LED Lights
- Search Results: 20142
- Shop: 7-Way Trailer Adapter for Towing Trailers with LED Lights
- Shop: 12V PWM Filter for RV Backup Camera Systems - Hardwire
- Shop: Dexter Nev-R-Adjust Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 7K
- Shop: Trailer Wiring Junction Box
- Shop: 7-Way to 4-Way/5-Way Trailer Adapter for Vehicles with Lamp-Out Sensors Towing Trailers with LEDs
- Q&A: Load Resistor For 2023 Ford F150 Tremor Towing Trailer With LED Lights
- Q&A: Solution for Furrion Camera Power and Trailer Tail Light Power on 2022 Chevy Silverado
- Q&A: Recommended 7-Way Trailer Adapter for Towing Trailers w/ LED Lights
- Q&A: Will 7-Way Adapter for Lamp-Out Sensors Work on 2020 GMC Sierra 3500
- Q&A: Will the 7-Way Trailer Adapter # C57003 Activate Trailer Brakes when Used on a 2014 VW Tiguan
- Q&A: Solution For A 2022 GMC Sierra 2500 That Is Causing LED Trailer Lights To Flash
- Q&A: Hopkins VueSMART Not Working on 2023 Chevy Silverado
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer wiring
- Search Results: trailer tires and wheels
- Shop: Suspension Enhancement
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Video: Curt Powered Tail Light Converter Installation - 2023 Kia Telluride
- Article: How to Measure for Trailer Hitch Drop
on Accessories and Parts
