Washer Needed to Install Dexter Trailer Idler Hub Assembly for 2,000-lb Axles
Updated 08/27/2019 | Published 08/26/2019
Products Featured in This Question
Question:
Thank you for the tremendous videos. My old hubs/bearings did not have an outer washer between the outer bearing and the nut. The video mentions the washer specifically. I have tried to size an appropriate washer from the hardware store but the washers I found did not fit over the spindle. Is this something I can order?
asked by: Charles
Expert Reply:
If the Dexter Trailer Idler Hub Assembly for 2,000-lb Axles # 8-91-05UC1 is what fits your axle/spindle then you can use the Spindle Nut Kit for EZ Lube Axles # RG05-100 for an EZ Lube spindle or parts # SW1000, # 6-190, and # 165686 for a standard spindle.
Product Page this Question was Asked From
Dexter Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - L44649 Bearings
- Trailer Hubs and Drums
- Idler Hub
- Standard
- L44649 / L44649
- Standard Grade
- For 2000 lbs Axles
- 1/2 Inch Stud
- 4 on 4 Inch
- 10 Inch Wheel
- 12 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Replacement Dexter Hub for 8-91A Hub
- Q&A: Recommended Replacement Hub for Dexter 8-91A
- Q&A: Needing Dexter Hub # 8-91A
- Q&A: What is Difference Between Trailer Bearings L44649 vs L44643
- Q&A: Replacement Bearings and Seals for a Dexter Hub with 8-91A Stamped on Back
- Q&A: Replacement for Dexter Hub 8-91A
- Q&A: Idler Hub for 2,200 lb Dexter Torsion Axle
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings