Tie Down Anchor Relocation Kit Required For a 2012 Ram Dually With Short Bed

Question

Question:

We have a 2012 Ram short bed with short bed and running boards to the end of the cab and factory installed hitch. The parts are TLD2120 and TLD3109. Do we need the relocation kit like the 2010 requires?

asked by: Ranae H

0

Expert Reply:

I checked with Torklift and they recommend when using # TLD2120 and # TLD3109 on a dually, first measure between the anchor points and if the measurement there is less than 90" you need the TorkLift Camper Anchor Relocation Kit # TLA7004 to increase anchor point width and clear the fenders.

expert reply by: Patrick R

0

Answer 1

You typically only need them on the front Reid. The HappiJac Extender Bracket for Dual Wheel Chassis Truck Camper Jacks item #HJ54FR are going to give you the necessary clearance to back your dually truck up so you can drop your camper in the bed.…

view full answer...

Answer 2

I spoke with Torklift about the TorkLift Camper Anchor Relocation Kit part #TLA7004 and they informed me that you could easily shorten the length if needed by simply overlapping the pieces of angle iron and then just drilling new holes to secure the…

view full answer...

Answer 3

The Torklift #TLA7004 Camper Anchor Relocation Kit does not require drilling into the camper or the truck. The adapter brackets would be attached to the camper by drilling holes at the location of the original anchor point, as shown in the photo…

view full answer...

Answer 4

We do have 6-Pole Square Trailer Wiring Connector Kit (Car and Trailer Ends) #37995 that you can use for your Arctic Fox camper. This is both the male and female ends. But the wires on them are 18 gauge. You could replace the ground and power wires…

view full answer...

Answer 5

The Swing Out Extension Brackets part #LC182496 which are for HappiJac Truck Camper Jacks will add approximately 3-1/2" - 4-1/2" of clearance to the existing jacks per side. This can then be used to determine compatibility. I would…

view full answer...

Answer 6

Hey Brian, thanks for reaching out. We do offer TorkLift frame mounter camper tie downs for your 2024 Ram 3500 6.4' bed with cab length steps. You will need the following: - TorkLift Camper Tie-Downs - Custom Frame Mount - Front #TLD2141…

view full answer...

Answer 7

Hey Jim welcome back. To determine if you need the TorkLift Camper Anchor Relocation Kit item #TLA7004, you'll have to take a measurement. You'll want to measure from the front bumper of your Palomino HS2902 to the center of the rear anchor…

view full answer...

Answer 8

Hello Ken, thanks for reaching out. Sounds like you are on the right track here because the type of running boards on your truck do dictate which tie downs to use. You are also correct that you will not be able to use the tie downs from your old 2002…

view full answer...

Answer 9

Hello Michael. The Torklift Tie Down Set #TL82DR is what I recommend for your 2012 Ram 2500 long bed. This kit comes with both the front and rear tie downs. It is important to note that these tie downs are intended for trucks without steps or running…

view full answer...

Answer 10

The correct Torklift Camper Tie Downs for your 2022 Ram 3500 would be the part #TLD2141 and #TLR3510 which is also correct for use with the Torklift 30k hitch that fits your truck part #TLD1111-30. Since you have a dually you will also need to…

view full answer...

Answer 11

I recommend using the Swing Out Extension Brackets for HappiJac Truck Camper Jack Systems item #LC182496 and the HappiJac Fixed Extender Bracket for Dual Wheel Chassis Truck Camper Jacks item #HJ54FR. The fixed extenders are only 5" wide apiece.…

view full answer...

Tie Down Anchor Relocation Kit Required For a 2012 Ram Dually With Short Bed

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching