Parts Needed to Wire a Winch on the Rear of a 2016 Ford F-350

Published 01/05/2019

Products Featured in This Question

Bulldog Winch Rear Wiring Kit - Quick Connect to Terminal End - 2 Gauge - 24' Long

(22)

$394.24

Bulldog Winch Receiver Mount Kit - 2" x 2"

(73)

$122.99

Question:

I have a 2016 f 350 diesel with 2 battery. I need to mount winch on back of truck in the receiver to pull cars out of field and on to driveway, and then take same winch and put on trailer to pull car on to it . What do I need to do to my truck to make this happen? Thanks

asked by: Brian

Expert Reply:

The Bulldog Winch Rear Wiring Kit part # BDW20207 is exactly what you are going to need to power even the most heavy duty of winches whether that be on the back of your truck or tongue of your trailer. The set of cables are going to run from either battery to the rear of the truck. The kit then comes with a separate quick connect fitting that you will need to install on the wire leads for your winch. This will the allow you to easily connect and disconnect the winch from the truck and install it on the trailer or vice versa.

If you need a winch mount for your truck then take a look at the Bulldog Winch Receiver Mount Kit part # BDW20155 which is suitable for most winches up to 12K that have a 10" x 4.5" mounting pattern but you can drill new holes if need be. I have attached an install/review video for you as well.

expert reply by: Conner L