Control Unit Recommendation for Lippert Kwikee Step Part Number 1800709

Question

Question:

Which unit do I need if my part # is 1800709?

asked by: Gary

1

Helpful Expert Reply:

The correct step control for you is the Lippert Components Kwikee Step Control with Override and PKD part # LC379605 based on the part number you mentioned and the picture you mentioned.

expert reply by: Jameson C

1

click to enlarge

Dan W.

7/25/2020

I have PN 909506000 step controller on 2004 beaver Monaco what is the replacement #

Chris R.

7/29/2020

The correct replacement control unit here is part # LC379606.

Answer 1

Based on the part number you have of 9514 the correct replacement control unit is the part #LC379606.

view full answer...

Answer 2

I spoke with Lippert and they were able to cross-reference "909511000" to the Kwikee Step Controller with Override part #LC381020 therefore this is the correct replacement for you.

view full answer...

Answer 3

To test your Control Module #LC379605 you'll need a 12v battery and an extra wire harness #LC369243 to connect the control module to the battery. You'll unplug the connector from the wire harness running to your motorhome's wiring and…

view full answer...

Answer 4

You are correct that Atwood was bought out by Lippert, and replacement parts are difficult to come by these days. I spoke to my contact at Lippert and your Atwood 66280 Level Leg system does not have any replacement parts available, so the…

view full answer...

Answer 5

The correct replacement motor for your older Atwood landing gear motor 71119 is the Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor #LC141893.

view full answer...

Answer 6

In order to test the motor on what I assume, based on your search history are a set of Kwikee Electric Steps, you will first want to sever the yellow and red wires on the motor. Once you do this you will then need to use a 12 volt power source you…

view full answer...

Answer 7

In October of 2004, Kwikee began shipping steps with an integrated motor/gear box/linkage (IMGL). If yours is older than 2004 then you should use item #LC379146. The Replacement Motor for Kwikee 42 Series Electric RV Steps item #LC379167 you…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Control Unit Recommendation for Lippert Kwikee Step Part Number 1800709

Product Page this Question was Asked From

Continue Researching