Kwikset Step Control Module Replacement for 9514

Question

Question:

Need replacement step control. We hav a kwkee 9514. Which one replaces it? Our rv is a ‘95

asked by: Lorene L

0

Expert Reply:

Based on the part number you have of 9514 the correct replacement control unit is the part # LC379606.

expert reply by: Jameson C

0

Answer 1

The correct step control for you is the Lippert Components Kwikee Step Control with Override and PKD part #LC379605 based on the part number you mentioned and the picture you mentioned.

view full answer...

Answer 2

I spoke with Lippert and they were able to cross-reference "909511000" to the Kwikee Step Controller with Override part #LC381020 therefore this is the correct replacement for you.

view full answer...

Answer 3

The correct replacement control module will depend on when your steps where manufactured. If the steps were manufactured in 2005 or earlier, you'd use part #LC379606. If the steps were manufactured after 2005, you'd use the part #LC379146.…

view full answer...

Answer 4

We have exactly what you are looking for. I reached out to my contact at Lippert who owns Kwikee Steps and based on the 9514 part number on your current control unit you will need the replacement control unit #LC379606. I included a video of the…

view full answer...

Answer 5

Actually the correct replacement for your Lippert 9514 controller would be the Replacement Control Unit for Kwikee Electric RV Steps #LC379606 not the Replacement Control Module for Lippert Electric Coach Step #LC301702. We have contacted Lippert in…

view full answer...

Answer 6

Since you have 2004 Kwikee Electric Steps, the correct replacement part is actually Motor Upgrade Kit for Kwikee Electric RV Steps #LC379145. Since the original Kwikee part was discontinued, you will need to replace the entire system in your step…

view full answer...

Answer 7

The only tank equipped RV water heat option we currently offer is the Dometic RV Water Heater part #DMC74FR which is a 120 volt unit with 6 gallon tank and gas/electric operation. In regards to installation, this must be performed by a qualified…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Kwikset Step Control Module Replacement for 9514

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching