Is a Solar Controller Needed to Install Redarc In-Vehicle BCDC Battery Charger
Updated 12/01/2024 | Published 10/30/2018 >
Products Featured in This Question
Question:
Is it required to have a solar controller between the solar panel and the BCDC 1225D? Or do you install the the solar panel directly to the BCDC 1225D via the yellow wire? Should a 20amp fuse be used on the input line?
asked by: David E
Helpful Expert Reply:
A solar controller is not required to install the Redarc In-Vehicle BCDC Battery Charger # 331-BCDC1225D, the solar panel does get connected to the charger directly via the yellow wire.
As for fuses you will need the 40-Amp MIDI Fuse Kit for Redarc In-Vehicle 25-Amp BCDC Battery Charger # 331-FK40 which gets installed as per the accompanying photos; it will depend on the type of battery (lead acid or Lithium ion) you are using.
I have added a link to a video review of this charger for you to check out, as well as a link to the installation instructions.

John
11/30/2024
Do you have the link for the video setup of the REDARC , DC to DC 40 amp charger for solar set up ?

Product Page this Question was Asked From
Redarc In-Vehicle BCDC Battery Charger - Dual Input - DC to DC - 12V/24V - 25 Amp
- Battery Charger
- Battery Charger
- RV/Camper
- Trailer
- 12V
- Charges and Maintains
- AGM
- Calcium
- Gel
- Lead Acid
- Lithium
- Solar Panels to Auxiliary Battery
- Vehicle Battery to Auxiliary Battery
- Smart Charge
- Trickle Charge
- Redarc
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Battery
- Q&A: Availability of Installation Video for Replacement Converter Section
- Shop: Progressive Dynamics 4000 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel - 60 Amp
- Shop: Progressive Dynamics 4000 Series Mini RV Converter w/ Charge Wizard and AC/DC Distribution Panel
- Shop: Replacement Converter Section for Progressive Dynamics Inteli-Power 4000 Series 45 Amp Power Center
- Shop: Replacement Converter Section for Progressive Dynamics Inteli-Power 4500 Series 75 Amp Power Center
- Search Results: trailer hitch
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Trailer Hitch
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Search Results: trailer wiring
- Video: Clean Up Your Trailer Wiring
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Should Thread Locker and Lock Washers be Used When Installing Curt Trailer Hitch Receiver
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Shop: Suspension Enhancement
- Video: HappiJac Original Turnbuckles for Camper Tie-Downs Feature Review
- Search Results: trailer tires and wheels
- Shop: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Way Coiled Adapter Cord
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Shop: Brake Controller
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Search Results: trailer jack
- Video: Mount: Curt Trailer Hitch Receiver on a 2003 Chevrolet Silverado
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Will B and W Trailer Hitch # BWHDRH25182 Fit Silverado And Allow for 285/70-17 Spare





Jason J.
6/12/2020
A few questions about the REDARC BCDC 1225d and a solar panel. I understand that I run the positive cable from the solar to the REDARC and connect it to the yellow wire but where do I connect the negative? Can I just ground it to the chassis in the engine compartment? When the engine is off will the REDARC still charge my auxiliary battery from the solar panel on the roof or does the ignition need to be on? Last question, do I need a fuse in between my solar panel and the REDARC yellow wire? Any information is appreciated!