Recommended Front Suspension Enhancement for a 2018 Thor Quantum Motorhome RC25

Question

Question:

How come your description of this item Timbren TFEF350 it says rated at 3000lbs? On Timbren official site, it rates their FEF350 at 2000lbs and their FEF350UH at 6000lbs. So does eTrailer.com have a special version of this item? I have a 2018 Thor Quantum RC25 Ford Class C E-450 chassis. Would like to know exactly what rating I would get with your item for my Front Suspention. Thank you.

asked by: Afchine

1

Helpful Expert Reply:

The Timbren Front Suspension Enhancement System part # TFEF350 is rated at 3,000 lbs and the Timbren Front Suspension Enhancement System part # TFEF350UH is rated at 6,000 lbs. I was able to call the manufacturer to confirm this.

They will both fit your 2018 Thor Quantum Motorhome RC25 on a Ford E-450 chassis but I recommend using the Timbren Front Suspension Enhancement System part # TFEF350UH as it will be better suited for your motorhome. This system is also very easy to install as you can see in the attached instructions. It will do an excellent job of improving stability and reducing body roll.

expert reply by: Conner L

1

Answer 1

Unfortunately the most comfortable ride can be subjective. My suggestion is that if at present time you have hard contact with factory axle bump stops on frame and a very rough or unstable ride in turns, I would definitely select the Timbren Front…

view full answer...

Answer 2

For a 2011 Ford E-350 Cube Van you would need the Timbren Front Suspension Enhancement System #TFEF350UH (approximately 4-7/8" tall) and the Timbren Rear Suspension Enhancement System #TFER35092LB (approximately 6-1/8" tall).

view full answer...

Answer 3

Hello again Rich; the higher rated #SSF-106-47 would be the better choice. However, since you really have this thing loaded and it is a work truck I recommend going with the Timbren SES #TFEF350UH. These have a capacity of 6,000 lbs so they can…

view full answer...

Answer 4

For your 1997 Ford E-450 Motorhome you could use SumoSprings Solo Custom Helper Springs Front Axle #SSF-106-47 as they are confirmed to fit. However, this setup has a 1,000lb weight capacity and is meant for light duty applications. For your…

view full answer...

Answer 5

I do have an option to get you more lift but the Lippert Axle Riser Kit part #LC382741 will not work on a Dexter Torflex Axle so you will need to use the Dexter Axle Riser Kit part #K71-707-02 if this is the route that you choose. The torsion axle…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Recommended Front Suspension Enhancement for a 2018 Thor Quantum Motorhome RC25

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching