Determining Torque Specs for Roadmaster Reflex Steering Stabilizer # RM-RBK22-RSSA

Question

Question:

What are torque specs for the bracket mounted to the frame?

asked by: Harold C

0

Expert Reply:

I have attached the complete installation instructions for the Roadmaster Reflex Steering Stabilizer # RM-RBK22-RSSA that you referenced. The torque specs for the included hardware can be found on page 2 of the instructions. We don't typically post these numbers on our site simply because they are always subject to change from the manufacturer.

To determine the correct torque specs when tightening factory bolts for the chassis/frame brackets, you will actually need to contact the RV's manufacturer for their specific recommendations. Roadmaster does not list this specification.

expert reply by: Chris R

0

Answer 1

Hey Paul, so your 2024 motorhome built on a Ford Cutaway chassis does have a 7-way at the rear and brake controller install wiring under the dash so all you'd need is the part #TK99UR which comes with the P3 brake controller and the correct…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 5

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Gladly! The difference between the Blue Ox Patriot 3 Radio Frequency, Portable Braking System BRK2019 and the Blue Ox Patriot Radio Frequency, Portable Braking System #BLU37TR is that the Blue Ox Patriot 3 RBRK2019 is older, no longer available, and…

view full answer...

Answer 8

Hey Don, congrats on the new truck and thanks for all of the information! I recommend the Roadmaster Direct-Connect Base Plate Kit - item #RM87NQ. Roadmaster's baseplate kits and wiring set the standards for flat towing as far as quality and…

view full answer...

Answer 9

Hey Bob! We are ahead of manufacturer fitment pretty often, and have confirmed that the Demco Tabless Base Plate Kit #DM38CV will fit the 2026 Maverick Hybrid. Our own etrailer Invisible Base Plate Kit #e96GV shares the same design so you can use…

view full answer...

Answer 10

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 11

Hey Will! I would be happy to help you get the best setup for your 2026 Ford Maverick Hybrid. You will need a tow bar, base plate kit, safety cables, wiring, and a supplemental brake system. I recommend the following: -Roadmaster Direct-Connect Base…

view full answer...

Answer 12

Hey Rick, the correct adapter to from a Blue Ox base plate like the part #BX2253 to a Demco tow bar would be the part #DM9523041 and you'd be set. Do you have the rest of your flat towing setup picked out already as well?

view full answer...

Determining Torque Specs for Roadmaster Reflex Steering Stabilizer # RM-RBK22-RSSA

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching