Is Trimming of Fascia Needed to Install Trailer Hitch in 2007 Lexus ES350?

Question

Question:

Will this fit the 2007 Lexus ES350 without have to cut or trim fascia or bumper, etc?

asked by: Cheryl

0

Expert Reply:

I took a look at the installation instructions for both the Curt # C12343 hitch and the Draw-Tite # 36416 hitch to see if any fascia would need to be trimmed, and the Curt mentions that it may require fascia trimming.

However, the Draw-Tite # 36416 will not, as you can see in the installation video I've linked showing the Draw-Tite being installed on a 2008 ES 350, which will be the same as on your '07 model.

expert reply by: Kyle S

0

click to enlarge

Answer 1

For a 2013 Camry, you'd want to use the Draw-Tite Class II, part #36540. This hitch will fit a vehicle with a dual exhaust. The #36416 hitch you referred to is a fit for the 2007-2011 Camry, so it won't fit your 2013 model.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 5

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 6

Hey Adrian! The higher capacity for the B&W #BW47BR and Curt #C77MJ comes from the construction. The B&W hitch weighs 45 lbs and then the Curt and Trailer Mate #TMT54FR both weigh 32 lbs. The Trailer Mate does sit just a tad higher compared…

view full answer...

Answer 7

Hey Ben! The Curt does have that restriction on the vertical bike racks so I recommend the TowSmart Trailer Hitch #TS82VR. This has a higher tongue weight capacity and will allow you to carry the VelociRAX. It would be a good idea to add the etrailer…

view full answer...

Answer 8

Hey Aaron, great question! The Trailer Mate Trailer Hitch Receiver #TMT67FR is definitely a budget friendly option for a hitch on your 2026 Highlander. This is basically the economy line from Curt. The welds are a little different (but will still do…

view full answer...

Answer 9

We sure do Billy and congrats on your new SUV. To add a hitch to your 2026 Mazda CX-50, I recommend our etrailer item #e55XV. This custom fit class III hitch has a 2" receiver, a 3,500 lbs towing capacity, and a maximum tongue weight of 525 lbs.…

view full answer...

Answer 10

Hey Eric. Welcome back and congrats on the new SUV. The Curt item #C26VV is listed as fitting the 2026 Grand Highlander but I have a better option for your 2026 Grand Highlander Hybrid Limited. It's our etailer item #e69ZV. We've actually…

view full answer...

Answer 11

The Hollywood Racks Trail Rider 2-Bike Rack #HR200 weighs about 35 lbs. The Swagman XC 2-Bike Rack #S64650 is lighter at about 26 lbs. The biggest difference between the two is the Swagman rack is rated for 2 bikes at 35 lbs each and the Hollywood…

view full answer...

Answer 12

The Swagman XTC4 4-Bike Rack #S64665 and Hollywood Racks Destination 4-Bike Rack #HR4000 are two of the best values in regards to 4-bike racks, and when taking everything into consideration I highly recommend the Destination #HR4000. There are a…

view full answer...

Is Trimming of Fascia Needed to Install Trailer Hitch in 2007 Lexus ES350?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching